From: Daniele Palmas <dnlplm@xxxxxxxxx>
[ Upstream commit eae7172f8141eb98e64e6e81acc9e9d5b2add127 ]
usbnet creates network interfaces with min_mtu = 0 and
max_mtu = ETH_MAX_MTU.
These values are not modified by qmi_wwan when the network interface
is created initially, allowing, for example, to set mtu greater than 1500.
When a raw_ip switch is done (raw_ip set to 'Y', then set to 'N') the mtu
values for the network interface are set through ether_setup, with
min_mtu = ETH_MIN_MTU and max_mtu = ETH_DATA_LEN, not allowing anymore to
set mtu greater than 1500 (error: mtu greater than device maximum).
The patch restores the original min/max mtu values set by usbnet after a
raw_ip switch.
Signed-off-by: Daniele Palmas <dnlplm@xxxxxxxxx>
Acked-by: Bjørn Mork <bjorn@xxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/net/usb/qmi_wwan.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/net/usb/qmi_wwan.c b/drivers/net/usb/qmi_wwan.c
index a04f8577d9f21..1d60ccd48ec29 100644
--- a/drivers/net/usb/qmi_wwan.c
+++ b/drivers/net/usb/qmi_wwan.c
@@ -274,6 +274,9 @@ static void qmi_wwan_netdev_setup(struct net_device *net)
netdev_dbg(net, "mode: raw IP\n");
} else if (!net->header_ops) { /* don't bother if already set */
ether_setup(net);
+ /* Restoring min/max mtu values set originally by usbnet */
+ net->min_mtu = 0;
+ net->max_mtu = ETH_MAX_MTU;
clear_bit(EVENT_NO_IP_ALIGN, &dev->flags);
netdev_dbg(net, "mode: Ethernet\n");
}
--
2.20.1
