Patch "Revert "usbcore: set lpm_capable field for LPM capable root hubs"" has been added to the 3.10-stable tree

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



This is a note to let you know that I've just added the patch titled

    Revert "usbcore: set lpm_capable field for LPM capable root hubs"

to the 3.10-stable tree which can be found at:
    http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary

The filename of the patch is:
     revert-usbcore-set-lpm_capable-field-for-lpm-capable-root-hubs.patch
and it can be found in the queue-3.10 subdirectory.

If you, or anyone else, feels it should not be added to the stable tree,
please let <stable@xxxxxxxxxxxxxxx> know about it.


>From 140e3026a57ab7d830dab2f2c57796c222db0ea9 Mon Sep 17 00:00:00 2001
From: Sarah Sharp <sarah.a.sharp@xxxxxxxxxxxxxxx>
Date: Wed, 22 Jan 2014 13:35:02 -0800
Subject: Revert "usbcore: set lpm_capable field for LPM capable root hubs"

From: Sarah Sharp <sarah.a.sharp@xxxxxxxxxxxxxxx>

commit 140e3026a57ab7d830dab2f2c57796c222db0ea9 upstream.

Commit 9df89d85b407690afa46ddfbccc80bec6869971d "usbcore: set
lpm_capable field for LPM capable root hubs" was created under the
assumption that all USB host controllers should have USB 3.0 Link PM
enabled for all devices under the hosts.

Unfortunately, that's not the case.  The xHCI driver relies on knowledge
of the host hardware scheduler to calculate the LPM U1/U2 timeout
values, and it only sets lpm_capable to one for Intel host controllers
(that have the XHCI_LPM_SUPPORT quirk set).

When LPM is enabled for some Fresco Logic hosts, it causes failures with
a AgeStar 3UBT USB 3.0 hard drive dock:

Jan 11 13:59:03 sg-laptop kernel: usb 3-1: new SuperSpeed USB device number 2 using xhci_hcd
Jan 11 13:59:03 sg-laptop kernel: usb 3-1: Set SEL for device-initiated U1 failed.
Jan 11 13:59:08 sg-laptop kernel: usb 3-1: Set SEL for device-initiated U2 failed.
Jan 11 13:59:08 sg-laptop kernel: usb-storage 3-1:1.0: USB Mass Storage device detected
Jan 11 13:59:08 sg-laptop mtp-probe[613]: checking bus 3, device 2: "/sys/devices/pci0000:00/0000:00:1c.3/0000:04:00.0/usb3/3-1"
Jan 11 13:59:08 sg-laptop mtp-probe[613]: bus: 3, device: 2 was not an MTP device
Jan 11 13:59:08 sg-laptop kernel: scsi6 : usb-storage 3-1:1.0
Jan 11 13:59:13 sg-laptop kernel: usb 3-1: Set SEL for device-initiated U1 failed.
Jan 11 13:59:18 sg-laptop kernel: usb 3-1: Set SEL for device-initiated U2 failed.
Jan 11 13:59:18 sg-laptop kernel: usbcore: registered new interface driver usb-storage
Jan 11 13:59:40 sg-laptop kernel: usb 3-1: reset SuperSpeed USB device number 2 using xhci_hcd
Jan 11 13:59:41 sg-laptop kernel: usb 3-1: device descriptor read/8, error -71
Jan 11 13:59:41 sg-laptop kernel: usb 3-1: reset SuperSpeed USB device number 2 using xhci_hcd
Jan 11 13:59:46 sg-laptop kernel: usb 3-1: device descriptor read/8, error -110
Jan 11 13:59:46 sg-laptop kernel: scsi 6:0:0:0: Device offlined - not ready after error recovery
Jan 11 13:59:46 sg-laptop kernel: usb 3-1: USB disconnect, device number 2

lspci for the affected host:

04:00.0 0c03: 1b73:1000 (rev 04) (prog-if 30 [XHCI])
        Subsystem: 1043:1039
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Latency: 0, Cache Line Size: 64 bytes
        Interrupt: pin A routed to IRQ 19
        Region 0: Memory at dd200000 (32-bit, non-prefetchable) [size=64K]
        Capabilities: [50] Power Management version 3
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold-)
                Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME-
        Capabilities: [68] MSI: Enable- Count=1/1 Maskable- 64bit+
                Address: 0000000000000000  Data: 0000
        Capabilities: [80] Express (v1) Endpoint, MSI 00
                DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s <2us, L1 <32us
                        ExtTag- AttnBtn- AttnInd- PwrInd- RBE+ FLReset-
                DevCtl: Report errors: Correctable- Non-Fatal- Fatal- Unsupported-
                        RlxdOrd+ ExtTag- PhantFunc- AuxPwr- NoSnoop+
                        MaxPayload 128 bytes, MaxReadReq 512 bytes
                DevSta: CorrErr- UncorrErr- FatalErr- UnsuppReq- AuxPwr- TransPend-
                LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Latency L0 unlimited, L1 unlimited
                        ClockPM- Surprise- LLActRep- BwNot-
                LnkCtl: ASPM Disabled; RCB 64 bytes Disabled- Retrain- CommClk+
                        ExtSynch- ClockPM- AutWidDis- BWInt- AutBWInt-
                LnkSta: Speed 2.5GT/s, Width x1, TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
        Kernel driver in use: xhci_hcd
        Kernel modules: xhci_hcd

The commit was backported to stable kernels, and will need to be
reverted there as well.

Signed-off-by: Sarah Sharp <sarah.a.sharp@xxxxxxxxx>
Reported-by: Sergey Galanov <sergey.e.galanov@xxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>

---
 drivers/usb/core/hcd.c |    1 -
 drivers/usb/core/hub.c |    7 +------
 drivers/usb/core/usb.h |    1 -
 3 files changed, 1 insertion(+), 8 deletions(-)

--- a/drivers/usb/core/hcd.c
+++ b/drivers/usb/core/hcd.c
@@ -1010,7 +1010,6 @@ static int register_root_hub(struct usb_
 					dev_name(&usb_dev->dev), retval);
 			return retval;
 		}
-		usb_dev->lpm_capable = usb_device_supports_lpm(usb_dev);
 	}
 
 	retval = usb_new_device (usb_dev);
--- a/drivers/usb/core/hub.c
+++ b/drivers/usb/core/hub.c
@@ -135,7 +135,7 @@ struct usb_hub *usb_hub_to_struct_hub(st
 	return usb_get_intfdata(hdev->actconfig->interface[0]);
 }
 
-int usb_device_supports_lpm(struct usb_device *udev)
+static int usb_device_supports_lpm(struct usb_device *udev)
 {
 	/* USB 2.1 (and greater) devices indicate LPM support through
 	 * their USB 2.0 Extended Capabilities BOS descriptor.
@@ -156,11 +156,6 @@ int usb_device_supports_lpm(struct usb_d
 				"Power management will be impacted.\n");
 		return 0;
 	}
-
-	/* udev is root hub */
-	if (!udev->parent)
-		return 1;
-
 	if (udev->parent->lpm_capable)
 		return 1;
 
--- a/drivers/usb/core/usb.h
+++ b/drivers/usb/core/usb.h
@@ -35,7 +35,6 @@ extern int usb_get_device_descriptor(str
 		unsigned int size);
 extern int usb_get_bos_descriptor(struct usb_device *dev);
 extern void usb_release_bos_descriptor(struct usb_device *dev);
-extern int usb_device_supports_lpm(struct usb_device *udev);
 extern char *usb_cache_string(struct usb_device *udev, int index);
 extern int usb_set_configuration(struct usb_device *dev, int configuration);
 extern int usb_choose_configuration(struct usb_device *udev);


Patches currently in stable-queue which might be from sarah.a.sharp@xxxxxxxxxxxxxxx are

queue-3.10/revert-usbcore-set-lpm_capable-field-for-lpm-capable-root-hubs.patch
--
To unsubscribe from this list: send the line "unsubscribe stable" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Linux Kernel]     [Kernel Development Newbies]     [Linux USB Devel]     [Video for Linux]     [Linux Audio Users]     [Yosemite Hiking]     [Linux Kernel]     [Linux SCSI]