From: Esben Haabendal <esben@xxxxxxxxxx>
commit d70486668cdf51b14a50425ab45fc18677a167b2 upstream.
As we reset the GPMI block at resume, the timing parameters setup by a
previous exec_op is lost. Rewriting GPMI timing registers on first exec_op
after resume fixes the problem.
Fixes: ef347c0cfd61 ("mtd: rawnand: gpmi: Implement exec_op")
Cc: stable@xxxxxxxxxxxxxxx
Signed-off-by: Esben Haabendal <esben@xxxxxxxxxx>
Acked-by: Han Xu <han.xu@xxxxxxx>
Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c | 4 ++++
1 file changed, 4 insertions(+)
--- a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
+++ b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.c
@@ -2727,6 +2727,10 @@ static int gpmi_pm_resume(struct device
return ret;
}
+ /* Set flag to get timing setup restored for next exec_op */
+ if (this->hw.clk_rate)
+ this->hw.must_apply_timings = true;
+
/* re-init the BCH registers */
ret = bch_set_geometry(this);
if (ret) {
