On Tue, Nov 5, 2019 at 2:29 AM Will Deacon <will@xxxxxxxxxx> wrote:
> On Mon, Nov 04, 2019 at 05:16:42PM -0800, John Stultz wrote:
> > On Tue, Oct 29, 2019 at 8:31 AM Catalin Marinas <catalin.marinas@xxxxxxx> wrote:
> > >
> > > Shared and writable mappings (__S.1.) should be clean (!dirty) initially
> > > and made dirty on a subsequent write either through the hardware DBM
> > > (dirty bit management) mechanism or through a write page fault. A clean
> > > pte for the arm64 kernel is one that has PTE_RDONLY set and PTE_DIRTY
> > > clear.
> > >
> > > The PAGE_SHARED{,_EXEC} attributes have PTE_WRITE set (PTE_DBM) and
> > > PTE_DIRTY clear. Prior to commit 73e86cb03cf2 ("arm64: Move PTE_RDONLY
> > > bit handling out of set_pte_at()"), it was the responsibility of
> > > set_pte_at() to set the PTE_RDONLY bit and mark the pte clean if the
> > > software PTE_DIRTY bit was not set. However, the above commit removed
> > > the pte_sw_dirty() check and the subsequent setting of PTE_RDONLY in
> > > set_pte_at() while leaving the PAGE_SHARED{,_EXEC} definitions
> > > unchanged. The result is that shared+writable mappings are now dirty by
> > > default
> > >
> > > Fix the above by explicitly setting PTE_RDONLY in PAGE_SHARED{,_EXEC}.
> > > In addition, remove the superfluous PTE_DIRTY bit from the kernel PROT_*
> > > attributes.
> > >
> > > Fixes: 73e86cb03cf2 ("arm64: Move PTE_RDONLY bit handling out of set_pte_at()")
> > > Cc: <stable@xxxxxxxxxxxxxxx> # 4.14.x-
> > > Cc: Will Deacon <will@xxxxxxxxxx>
> > > Signed-off-by: Catalin Marinas <catalin.marinas@xxxxxxx>
> >
> > Hey,
> > So I'm not yet sure why, but I've just validated that this patch is
> > causing trouble with booting AOSP on HiKey960 with 5.4-rc6 (-rc5 works
> > fine).
>
> Hmm. Annoying this wasn't spotted by CI.
>
> > Its odd, because the system does boot and is alive, but seems to stall
> > out at the boot animation, and userland never finishes coming up to
> > the home screen. It just sits there without a useful error message
> > that I can find so far. Reverting just this patch seems to solve it
> > and it boots all the way.
>
> Given that I don't think the HiKey960 supports h/w DBM, my initial guess
> is that the GPU is stuck on a page fault.
>
> > I'll try to dig further to see what might be going on (the mali driver
> > is a prime suspect here), but I wanted to raise the flag since we're
> > at the end of the -rc cycle.
>
> What exactly are you using for the mali driver?
>
> As an experiment, can you try reverting just the part of the patch that
> removes PTE_DIRTY from the PROT_* definitions? (see below)
So reverting just the bit you sent here re-adding the PTE_DIRTY bit
didn't seem to fix it. I still see things stalling at the boot
animation.
thanks
-john
