From: Junaid Shahid <junaids@xxxxxxxxxx>
commit a468f2dbf921d02f5107378501693137a812999b upstream.
Currently, KVM flushes the TLB after a change to the APIC access page
address or the APIC mode when EPT mode is enabled. However, even in
shadow paging mode, a TLB flush is needed if VPIDs are being used, as
specified in the Intel SDM Section 29.4.5.
So replace vmx_flush_tlb_ept_only() with vmx_flush_tlb(), which will
flush if either EPT or VPIDs are in use.
Signed-off-by: Junaid Shahid <junaids@xxxxxxxxxx>
Reviewed-by: Jim Mattson <jmattson@xxxxxxxxxx>
Signed-off-by: Radim Krčmář <rkrcmar@xxxxxxxxxx>
Cc: "Jitindar SIngh, Suraj" <surajjs@xxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
arch/x86/kvm/vmx.c | 14 ++++----------
1 file changed, 4 insertions(+), 10 deletions(-)
--- a/arch/x86/kvm/vmx.c
+++ b/arch/x86/kvm/vmx.c
@@ -4444,12 +4444,6 @@ static void vmx_flush_tlb(struct kvm_vcp
__vmx_flush_tlb(vcpu, to_vmx(vcpu)->vpid, invalidate_gpa);
}
-static void vmx_flush_tlb_ept_only(struct kvm_vcpu *vcpu)
-{
- if (enable_ept)
- vmx_flush_tlb(vcpu, true);
-}
-
static void vmx_decache_cr0_guest_bits(struct kvm_vcpu *vcpu)
{
ulong cr0_guest_owned_bits = vcpu->arch.cr0_guest_owned_bits;
@@ -9320,7 +9314,7 @@ static void vmx_set_virtual_x2apic_mode(
} else {
sec_exec_control &= ~SECONDARY_EXEC_VIRTUALIZE_X2APIC_MODE;
sec_exec_control |= SECONDARY_EXEC_VIRTUALIZE_APIC_ACCESSES;
- vmx_flush_tlb_ept_only(vcpu);
+ vmx_flush_tlb(vcpu, true);
}
vmcs_write32(SECONDARY_VM_EXEC_CONTROL, sec_exec_control);
@@ -9348,7 +9342,7 @@ static void vmx_set_apic_access_page_add
!nested_cpu_has2(get_vmcs12(&vmx->vcpu),
SECONDARY_EXEC_VIRTUALIZE_APIC_ACCESSES)) {
vmcs_write64(APIC_ACCESS_ADDR, hpa);
- vmx_flush_tlb_ept_only(vcpu);
+ vmx_flush_tlb(vcpu, true);
}
}
@@ -11243,7 +11237,7 @@ static int prepare_vmcs02(struct kvm_vcp
}
} else if (nested_cpu_has2(vmcs12,
SECONDARY_EXEC_VIRTUALIZE_APIC_ACCESSES)) {
- vmx_flush_tlb_ept_only(vcpu);
+ vmx_flush_tlb(vcpu, true);
}
/*
@@ -12198,7 +12192,7 @@ static void nested_vmx_vmexit(struct kvm
} else if (!nested_cpu_has_ept(vmcs12) &&
nested_cpu_has2(vmcs12,
SECONDARY_EXEC_VIRTUALIZE_APIC_ACCESSES)) {
- vmx_flush_tlb_ept_only(vcpu);
+ vmx_flush_tlb(vcpu, true);
}
/* This is needed for same reason as it was needed in prepare_vmcs02 */
