Hello,
+Russell who might have thoughts about the issue
Miquel Raynal <miquel.raynal@xxxxxxxxxxx> wrote on Fri, 18 Oct 2019
16:36:43 +0200:
> Any write with either dd or flashcp to a device driven by the
> spear_smi.c driver will pass through the spear_smi_cpy_toio()
> function. This function will get called for chunks of up to 256 bytes.
> If the amount of data is smaller, we may have a problem if the data
> length is not 4-byte aligned. In this situation, the kernel panics
> during the memcpy:
>
> # dd if=/dev/urandom bs=1001 count=1 of=/dev/mtd6
> spear_smi_cpy_toio [620] dest c9070000, src c7be8800, len 256
> spear_smi_cpy_toio [620] dest c9070100, src c7be8900, len 256
> spear_smi_cpy_toio [620] dest c9070200, src c7be8a00, len 256
> spear_smi_cpy_toio [620] dest c9070300, src c7be8b00, len 233
> Unhandled fault: external abort on non-linefetch (0x808) at 0xc90703e8
> [...]
> PC is at memcpy+0xcc/0x330
>
> Workaround this issue by using the alternate _memcpy_toio() method
> which at least does not present the same problem.
>
> Fixes: f18dbbb1bfe0 ("mtd: ST SPEAr: Add SMI driver for serial NOR flash")
> Cc: stable@xxxxxxxxxxxxxxx
> Suggested-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxx>
> Signed-off-by: Miquel Raynal <miquel.raynal@xxxxxxxxxxx>
> ---
>
> Hello,
>
> This patch could not be tested with a mainline kernel (only compiled)
> but was tested with a stable 4.14.x kernel. I have really no idea why
> memcpy fails in this situation that's why I propose this workaround
> but I bet there is something deeper not working.
I did not mention that the opposite direction using memcpy_fromio() does
not present any issue.
>
> Thanks,
> Miquèl
>
> drivers/mtd/devices/spear_smi.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/mtd/devices/spear_smi.c b/drivers/mtd/devices/spear_smi.c
> index 986f81d2f93e..d888625a3244 100644
> --- a/drivers/mtd/devices/spear_smi.c
> +++ b/drivers/mtd/devices/spear_smi.c
> @@ -614,7 +614,7 @@ static inline int spear_smi_cpy_toio(struct spear_smi *dev, u32 bank,
> ctrlreg1 = readl(dev->io_base + SMI_CR1);
> writel((ctrlreg1 | WB_MODE) & ~SW_MODE, dev->io_base + SMI_CR1);
>
> - memcpy_toio(dest, src, len);
> + _memcpy_toio(dest, src, len);
>
> writel(ctrlreg1, dev->io_base + SMI_CR1);
>
Thanks,
Miquèl
