From: Fabrice Gasnier <fabrice.gasnier@xxxxxx>
[ Upstream commit c91e3234c6035baf5a79763cb4fcd5d23ce75c2b ]
LPTimer can use a 32KHz clock for counting. It depends on clock tree
configuration. In such a case, PWM output frequency range is limited.
Although unlikely, nothing prevents user from requesting a PWM frequency
above counting clock (32KHz for instance):
- This causes (prd - 1) = 0xffff to be written in ARR register later in
the apply() routine.
This results in badly configured PWM period (and also duty_cycle).
Add a check to report an error is such a case.
Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxx>
Reviewed-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx>
Signed-off-by: Thierry Reding <thierry.reding@xxxxxxxxx>
Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx>
---
drivers/pwm/pwm-stm32-lp.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/pwm/pwm-stm32-lp.c b/drivers/pwm/pwm-stm32-lp.c
index 0059b24cfdc3c..28e1f64134763 100644
--- a/drivers/pwm/pwm-stm32-lp.c
+++ b/drivers/pwm/pwm-stm32-lp.c
@@ -58,6 +58,12 @@ static int stm32_pwm_lp_apply(struct pwm_chip *chip, struct pwm_device *pwm,
/* Calculate the period and prescaler value */
div = (unsigned long long)clk_get_rate(priv->clk) * state->period;
do_div(div, NSEC_PER_SEC);
+ if (!div) {
+ /* Clock is too slow to achieve requested period. */
+ dev_dbg(priv->chip.dev, "Can't reach %u ns\n", state->period);
+ return -EINVAL;
+ }
+
prd = div;
while (div > STM32_LPTIM_MAX_ARR) {
presc++;
--
2.20.1
