From: Song Liu <songliubraving@xxxxxx> commit a25d8c327bb41742dbd59f8c545f59f3b9c39983 upstream. This reverts commit 4f4fd7c5798bbdd5a03a60f6269cf1177fbd11ef. Cc: Dan Williams <dan.j.williams@xxxxxxxxx> Cc: Nigel Croxon <ncroxon@xxxxxxxxxx> Cc: Xiao Ni <xni@xxxxxxxxxx> Signed-off-by: Song Liu <songliubraving@xxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/md/raid5.c | 19 +++++++++++++++---- 1 file changed, 15 insertions(+), 4 deletions(-) --- a/drivers/md/raid5.c +++ b/drivers/md/raid5.c @@ -4223,15 +4223,26 @@ static void handle_parity_checks6(struct case check_state_check_result: sh->check_state = check_state_idle; - if (s->failed > 1) - break; /* handle a successful check operation, if parity is correct * we are done. Otherwise update the mismatch count and repair * parity if !MD_RECOVERY_CHECK */ if (sh->ops.zero_sum_result == 0) { - /* Any parity checked was correct */ - set_bit(STRIPE_INSYNC, &sh->state); + /* both parities are correct */ + if (!s->failed) + set_bit(STRIPE_INSYNC, &sh->state); + else { + /* in contrast to the raid5 case we can validate + * parity, but still have a failure to write + * back + */ + sh->check_state = check_state_compute_result; + /* Returning at this point means that we may go + * off and bring p and/or q uptodate again so + * we make sure to check zero_sum_result again + * to verify if p or q need writeback + */ + } } else { atomic64_add(STRIPE_SECTORS, &conf->mddev->resync_mismatches); if (test_bit(MD_RECOVERY_CHECK, &conf->mddev->recovery)) {