From: Ido Schimmel <idosch@xxxxxxxxxxxx> [ Upstream commit 1ab3030193d25878b3b1409060e1e0a879800c95 ] During driver initialization the driver sends a reset to the device and waits for the firmware to signal that it is ready to continue. Commit d2f372ba0914 ("mlxsw: pci: Increase PCI SW reset timeout") increased the timeout to 13 seconds due to longer PHY calibration in Spectrum-2 compared to Spectrum-1. Recently it became apparent that this timeout is too short and therefore this patch increases it again to a safer limit that will be reduced in the future. Fixes: c3ab435466d5 ("mlxsw: spectrum: Extend to support Spectrum-2 ASIC") Fixes: d2f372ba0914 ("mlxsw: pci: Increase PCI SW reset timeout") Signed-off-by: Ido Schimmel <idosch@xxxxxxxxxxxx> Acked-by: Jiri Pirko <jiri@xxxxxxxxxxxx> Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/net/ethernet/mellanox/mlxsw/pci_hw.h | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) --- a/drivers/net/ethernet/mellanox/mlxsw/pci_hw.h +++ b/drivers/net/ethernet/mellanox/mlxsw/pci_hw.h @@ -27,7 +27,7 @@ #define MLXSW_PCI_SW_RESET 0xF0010 #define MLXSW_PCI_SW_RESET_RST_BIT BIT(0) -#define MLXSW_PCI_SW_RESET_TIMEOUT_MSECS 13000 +#define MLXSW_PCI_SW_RESET_TIMEOUT_MSECS 20000 #define MLXSW_PCI_SW_RESET_WAIT_MSECS 100 #define MLXSW_PCI_FW_READY 0xA1844 #define MLXSW_PCI_FW_READY_MASK 0xFFFF