From: Nicholas Kazlauskas <nicholas.kazlauskas@xxxxxxx> [ Upstream commit 0921c41e19028314830b33daa681e46b46477c5e ] [Why] If the cursor pos passed from DM is less than the plane_state->dst_rect top left corner then the unsigned cursor pos wraps around to a large positive number since cursor pos is a u32. There was an attempt to guard against this in hubp1_cursor_set_position by checking the src_x_offset and src_y_offset and offseting the cursor hotspot within hubp1_cursor_set_position. However, the cursor position itself is still being programmed incorrectly as a large value. This manifests itself visually as the cursor disappearing or containing strange artifacts near the middle of the screen on raven. [How] Don't subtract the destination rect top left corner from the pos but add it to the hotspot instead. This happens before the pos gets passed into hubp1_cursor_set_position. This achieves the same result but avoids the subtraction wrap around. With this fix the original cursor programming logic can be used again. Signed-off-by: Nicholas Kazlauskas <nicholas.kazlauskas@xxxxxxx> Reviewed-by: Charlene Liu <Charlene.Liu@xxxxxxx> Acked-by: Leo Li <sunpeng.li@xxxxxxx> Acked-by: Murton Liu <Murton.Liu@xxxxxxx> Signed-off-by: Alex Deucher <alexander.deucher@xxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c b/drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c index 220ba828748d..5bc214ce5227 100644 --- a/drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c +++ b/drivers/gpu/drm/amd/display/dc/dcn10/dcn10_hw_sequencer.c @@ -2654,8 +2654,8 @@ static void dcn10_set_cursor_position(struct pipe_ctx *pipe_ctx) .mirror = pipe_ctx->plane_state->horizontal_mirror }; - pos_cpy.x -= pipe_ctx->plane_state->dst_rect.x; - pos_cpy.y -= pipe_ctx->plane_state->dst_rect.y; + pos_cpy.x_hotspot += pipe_ctx->plane_state->dst_rect.x; + pos_cpy.y_hotspot += pipe_ctx->plane_state->dst_rect.y; if (pipe_ctx->plane_state->address.type == PLN_ADDR_TYPE_VIDEO_PROGRESSIVE) -- 2.19.1
