On Fri, Jan 25, 2019 at 03:26:16PM -0800, Bjorn Andersson wrote:
> Acquiring the reset GPIO low means that reset is being deasserted, this
> is followed almost immediately with qcom_pcie_host_init() asserting it,
> initializing it and then finally deasserting it again, for the link to
> come up.
>
> Some PCIe devices requires a minimum time between the initial deassert
> and subsequent reset cycles. In a platform that boots with the reset
> GPIO asserted this requirement is being violated by this deassert/assert
> pulse.
>
> Acquiring the reset GPIO high will prevent this by matching the state to
> the subsequent asserted state.
>
> Cc: stable@xxxxxxxxxxxxxxx
Missing Fixes: tag, please provide me one so that I can proceed.
Lorenzo
> Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx>
> ---
> drivers/pci/controller/dwc/pcie-qcom.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> index d185ea5fe996..a7f703556790 100644
> --- a/drivers/pci/controller/dwc/pcie-qcom.c
> +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> @@ -1228,7 +1228,7 @@ static int qcom_pcie_probe(struct platform_device *pdev)
>
> pcie->ops = of_device_get_match_data(dev);
>
> - pcie->reset = devm_gpiod_get_optional(dev, "perst", GPIOD_OUT_LOW);
> + pcie->reset = devm_gpiod_get_optional(dev, "perst", GPIOD_OUT_HIGH);
> if (IS_ERR(pcie->reset)) {
> ret = PTR_ERR(pcie->reset);
> goto err_pm_runtime_put;
> --
> 2.18.0
>
