From: Marcel Ziswiler <marcel.ziswiler@xxxxxxxxxxx> [ Upstream commit 4c9a27a6c66d4427f3cba4019d4ba738fe99fa87 ] Since commit f8f8f1d04494 ("clk: Don't touch hardware when reparenting during registration") ULPI has been broken on Tegra20 leading to the following error message during boot: [ 1.974698] ulpi_phy_power_on: ulpi write failed [ 1.979384] tegra-ehci c5004000.usb: Failed to power on the phy [ 1.985434] tegra-ehci: probe of c5004000.usb failed with error -110 Debugging through the changes and finally also consulting the TRM revealed that rather than the CDEV2 clock off OSC requiring such pin muxing actually the PLL_P_OUT4 clock is in use. It looks like so far it just worked by chance of that one having been enabled which Stephen's commit now changed when reparenting sclk away from pll_p_out4 leaving that one disabled. Fix this by properly assigning the PLL_P_OUT4 clock as the ULPI PHY clock. Signed-off-by: Marcel Ziswiler <marcel.ziswiler@xxxxxxxxxxx> Reviewed-by: Dmitry Osipenko <digetx@xxxxxxxxx> Reviewed-by: Rob Herring <robh@xxxxxxxxxx> Signed-off-by: Thierry Reding <treding@xxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- arch/arm/boot/dts/tegra20.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/tegra20.dtsi b/arch/arm/boot/dts/tegra20.dtsi index 914f59166a99..2780e68a853b 100644 --- a/arch/arm/boot/dts/tegra20.dtsi +++ b/arch/arm/boot/dts/tegra20.dtsi @@ -706,7 +706,7 @@ phy_type = "ulpi"; clocks = <&tegra_car TEGRA20_CLK_USB2>, <&tegra_car TEGRA20_CLK_PLL_U>, - <&tegra_car TEGRA20_CLK_CDEV2>; + <&tegra_car TEGRA20_CLK_PLL_P_OUT4>; clock-names = "reg", "pll_u", "ulpi-link"; resets = <&tegra_car 58>, <&tegra_car 22>; reset-names = "usb", "utmi-pads"; -- 2.17.1