A recent change added some MDS processing in the lpfc_drain_txq
routine that relies on the fcp_wq being allocated. For nvmet operation
the fcp_wq is not allocated because it can only be an nvme-target.
When the original MDS support was added LS_MDS_LOOPBACK was
defined wrong, (0x16) it should have been 0x10 (decimal value used for
hex setting). This incorrect value allowed MDS_LOOPBACK to be set
simultaneously with LS_NPIV_FAB_SUPPORTED, causing the driver to
crash when it accesses the non-existent fcp_wq.
Correct the bad value setting for LS_MDS_LOOPBACK.
Fixes: ae9e28f36a6c ("lpfc: Add MDS Diagnostic support.")
Cc: <stable@xxxxxxxxxxxxxxx> # 4.12
Signed-off-by: Dick Kennedy <dick.kennedy@xxxxxxxxxxxx>
Signed-off-by: James Smart <james.smart@xxxxxxxxxxxx>
---
drivers/scsi/lpfc/lpfc.h | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/scsi/lpfc/lpfc.h b/drivers/scsi/lpfc/lpfc.h
index e0d0da5f43d6..43732e8d1347 100644
--- a/drivers/scsi/lpfc/lpfc.h
+++ b/drivers/scsi/lpfc/lpfc.h
@@ -672,7 +672,7 @@ struct lpfc_hba {
#define LS_NPIV_FAB_SUPPORTED 0x2 /* Fabric supports NPIV */
#define LS_IGNORE_ERATT 0x4 /* intr handler should ignore ERATT */
#define LS_MDS_LINK_DOWN 0x8 /* MDS Diagnostics Link Down */
-#define LS_MDS_LOOPBACK 0x16 /* MDS Diagnostics Link Up (Loopback) */
+#define LS_MDS_LOOPBACK 0x10 /* MDS Diagnostics Link Up (Loopback) */
uint32_t hba_flag; /* hba generic flags */
#define HBA_ERATT_HANDLED 0x1 /* This flag is set when eratt handled */
--
2.13.1
