4.14-stable review patch. If anyone has any objections, please let me know.
------------------
From: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
[ Upstream commit 0921e11e1e12802ae0a3c19cb02e33354ca51967 ]
According to section 59.2.4 MSIOF Receive Mode Register 1 (SIRMDR1) in
the R-Car Gen3 datasheet Rev.1.00, the value of the SIRMDR1.SYNCAC bit
must match the value of the SITMDR1.SYNCAC bit. However,
sh_msiof_spi_setup() changes only the latter.
Fix this by updating the SIRMDR1 register like the SITMDR1 register,
taking into account register bits that exist in SITMDR1 only.
Reported-by: Renesas BSP team via Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
Fixes: 7ff0b53c4051145d ("spi: sh-msiof: Avoid writing to registers from spi_master.setup()")
Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
Reviewed-by: Simon Horman <horms+renesas@xxxxxxxxxxxx>
Signed-off-by: Mark Brown <broonie@xxxxxxxxxx>
Signed-off-by: Sasha Levin <alexander.levin@xxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/spi/spi-sh-msiof.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
--- a/drivers/spi/spi-sh-msiof.c
+++ b/drivers/spi/spi-sh-msiof.c
@@ -555,14 +555,16 @@ static int sh_msiof_spi_setup(struct spi
/* Configure native chip select mode/polarity early */
clr = MDR1_SYNCMD_MASK;
- set = MDR1_TRMD | TMDR1_PCON | MDR1_SYNCMD_SPI;
+ set = MDR1_SYNCMD_SPI;
if (spi->mode & SPI_CS_HIGH)
clr |= BIT(MDR1_SYNCAC_SHIFT);
else
set |= BIT(MDR1_SYNCAC_SHIFT);
pm_runtime_get_sync(&p->pdev->dev);
tmp = sh_msiof_read(p, TMDR1) & ~clr;
- sh_msiof_write(p, TMDR1, tmp | set);
+ sh_msiof_write(p, TMDR1, tmp | set | MDR1_TRMD | TMDR1_PCON);
+ tmp = sh_msiof_read(p, RMDR1) & ~clr;
+ sh_msiof_write(p, RMDR1, tmp | set);
pm_runtime_put(&p->pdev->dev);
p->native_cs_high = spi->mode & SPI_CS_HIGH;
p->native_cs_inited = true;
