The changes are to make sure to check the operation status.
Actually the flash write and erase error behavior is caused on our products.
The flash is Macronix flash device MX29GL512FHT2I-11G used by our products.
The patch series was separated for changes of flash write and erase.
Since those were not depended each other at the time.
But by additional changes the changes are related more as same way currently.
So combine patch series for the flash write and erase changes as v6.
Signed-off-by: Tokunori Ikegami <ikegami@xxxxxxxxxxxxxxxxxxxx>
Reviewed-by: Joakim Tjernlund <Joakim.Tjernlund@xxxxxxxxxxxx>
Cc: Chris Packham <chris.packham@xxxxxxxxxxxxxxxxxxx>
Cc: Brian Norris <computersforpeace@xxxxxxxxx>
Cc: David Woodhouse <dwmw2@xxxxxxxxxxxxx>
Cc: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx>
Cc: Marek Vasut <marek.vasut@xxxxxxxxx>
Cc: Richard Weinberger <richard@xxxxxx>
Cc: Cyrille Pitchen <cyrille.pitchen@xxxxxxxxxx>
Cc: linux-mtd@xxxxxxxxxxxxxxxxxxx
Cc: stable@xxxxxxxxxxxxxxx
Tokunori Ikegami (5):
mtd: cfi_cmdset_0002: Change write buffer to check correct value
mtd: cfi_cmdset_0002: Change definition naming to retry write
operation
mtd: cfi_cmdset_0002: Change erase functions to retry for error
mtd: cfi_cmdset_0002: Change erase functions to check chip good only
mtd: cfi_cmdset_0002: Change erase one block to enable XIP once
drivers/mtd/chips/cfi_cmdset_0002.c | 36 +++++++++++++++++++++++-------------
1 file changed, 23 insertions(+), 13 deletions(-)
--
2.16.1
