Hi,
Sorry changelogs have not been described by the v7 patches so let me send mail about this.
There is no change from the v6 patches but just changed the commit messages to change and add CC lines as below.
1. Change
- Cc: Joakim Tjernlund <Joakim.Tjernlund@xxxxxxxxxxxx>
+ Reviewed-by: Joakim Tjernlund <Joakim.Tjernlund@xxxxxxxxxxxx>
2. Add
+ Cc: stable@xxxxxxxxxxxxxxx
Regards,
Ikegami
> -----Original Message-----
> From: Tokunori Ikegami [mailto:ikegami@xxxxxxxxxxxxxxxxxxxx]
> Sent: Monday, May 28, 2018 8:28 AM
> To: Boris Brezillon
> Cc: IKEGAMI Tokunori; PACKHAM Chris; Brian Norris; David Woodhouse; Boris
> Brezillon; Marek Vasut; Richard Weinberger; Cyrille Pitchen;
> linux-mtd@xxxxxxxxxxxxxxxxxxx; stable@xxxxxxxxxxxxxxx
> Subject: [PATCH v7 0/5] mtd: cfi_cmdset_0002: Change write and erase
> functions
>
> The changes are to make sure to check the operation status.
> Actually the flash write and erase error behavior is caused on our products.
> The flash is Macronix flash device MX29GL512FHT2I-11G used by our products.
> The patch series was separated for changes of flash write and erase.
> Since those were not depended each other at the time.
> But by additional changes the changes are related more as same way currently.
> So combine patch series for the flash write and erase changes as v6.
>
> Signed-off-by: Tokunori Ikegami <ikegami@xxxxxxxxxxxxxxxxxxxx>
> Reviewed-by: Joakim Tjernlund <Joakim.Tjernlund@xxxxxxxxxxxx>
> Cc: Chris Packham <chris.packham@xxxxxxxxxxxxxxxxxxx>
> Cc: Brian Norris <computersforpeace@xxxxxxxxx>
> Cc: David Woodhouse <dwmw2@xxxxxxxxxxxxx>
> Cc: Boris Brezillon <boris.brezillon@xxxxxxxxxxxxxxxxxx>
> Cc: Marek Vasut <marek.vasut@xxxxxxxxx>
> Cc: Richard Weinberger <richard@xxxxxx>
> Cc: Cyrille Pitchen <cyrille.pitchen@xxxxxxxxxx>
> Cc: linux-mtd@xxxxxxxxxxxxxxxxxxx
> Cc: stable@xxxxxxxxxxxxxxx
>
> Tokunori Ikegami (5):
> mtd: cfi_cmdset_0002: Change write buffer to check correct value
> mtd: cfi_cmdset_0002: Change definition naming to retry write
> operation
> mtd: cfi_cmdset_0002: Change erase functions to retry for error
> mtd: cfi_cmdset_0002: Change erase functions to check chip good only
> mtd: cfi_cmdset_0002: Change erase one block to enable XIP once
>
> drivers/mtd/chips/cfi_cmdset_0002.c | 36
> +++++++++++++++++++++++-------------
> 1 file changed, 23 insertions(+), 13 deletions(-)
>
> --
> 2.16.1
