Jeremy Cline correctly points out in rhbz#1514836 that a device where the QCA rome chipset needs the USB_QUIRK_RESET_RESUME quirk, may also ship with a different wifi/bt chipset in some configurations. If that is the case then we are needlessly penalizing those other chipsets with a reset-resume quirk, typically causing 0.4W extra power use because this disables runtime-pm. This commit moves the DMI table check to a btusb_check_needs_reset_resume() helper (so that we can easily also call it for other chipsets) and calls this new helper only for QCA_ROME chipsets for now. BugLink: https://bugzilla.redhat.com/show_bug.cgi?id=1514836 Cc: stable@xxxxxxxxxxxxxxx Cc: Jeremy Cline <jcline@xxxxxxxxxx> Suggested-by: Jeremy Cline <jcline@xxxxxxxxxx> Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- drivers/bluetooth/btusb.c | 10 +++++++--- 1 file changed, 7 insertions(+), 3 deletions(-) diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c index f064984c9ec0..15e7cdca6eb5 100644 --- a/drivers/bluetooth/btusb.c +++ b/drivers/bluetooth/btusb.c @@ -2863,6 +2863,12 @@ static int btusb_config_oob_wake(struct hci_dev *hdev) } #endif +static void btusb_check_needs_reset_resume(struct usb_interface *intf) +{ + if (dmi_check_system(btusb_needs_reset_resume_table)) + interface_to_usbdev(intf)->quirks |= USB_QUIRK_RESET_RESUME; +} + static int btusb_probe(struct usb_interface *intf, const struct usb_device_id *id) { @@ -2985,9 +2991,6 @@ static int btusb_probe(struct usb_interface *intf, hdev->send = btusb_send_frame; hdev->notify = btusb_notify; - if (dmi_check_system(btusb_needs_reset_resume_table)) - interface_to_usbdev(intf)->quirks |= USB_QUIRK_RESET_RESUME; - #ifdef CONFIG_PM err = btusb_config_oob_wake(hdev); if (err) @@ -3076,6 +3079,7 @@ static int btusb_probe(struct usb_interface *intf, data->setup_on_usb = btusb_setup_qca; hdev->set_bdaddr = btusb_set_bdaddr_ath3012; set_bit(HCI_QUIRK_SIMULTANEOUS_DISCOVERY, &hdev->quirks); + btusb_check_needs_reset_resume(intf); } #ifdef CONFIG_BT_HCIBTUSB_RTL -- 2.17.0
