From: chenxiang <chenxiang66@xxxxxxxxxxxxx> [ Upstream commit affc67788fe5dfffad5cda3d461db5cf2b2ff2b0 ] The status of SAS PHY is in sas_phy->enabled. There is an issue that the status of a remote SAS PHY may be initialized incorrectly: if disable remote SAS PHY through sysfs interface (such as echo 0 > /sys/class/sas_phy/phy-1:0:0/enable), then reboot the system, and we will find the status of remote SAS PHY which is disabled before is 1 (cat /sys/class/sas_phy/phy-1:0:0/enable). But actually the status of remote SAS PHY is disabled and the device attached is not found. In SAS protocol, NEGOTIATED LOGICAL LINK RATE field of DISCOVER response is 0x1 when remote SAS PHY is disabled. So initialize sas_phy->enabled according to the value of NEGOTIATED LOGICAL LINK RATE field. Signed-off-by: chenxiang <chenxiang66@xxxxxxxxxxxxx> Reviewed-by: John Garry <john.garry@xxxxxxxxxx> Signed-off-by: Jason Yan <yanaijie@xxxxxxxxxx> Reviewed-by: Christoph Hellwig <hch@xxxxxx> Reviewed-by: Hannes Reinecke <hare@xxxxxxxx> Signed-off-by: Martin K. Petersen <martin.petersen@xxxxxxxxxx> Signed-off-by: Sasha Levin <alexander.levin@xxxxxxxxxxxxx> --- drivers/scsi/libsas/sas_expander.c | 1 + 1 file changed, 1 insertion(+) diff --git a/drivers/scsi/libsas/sas_expander.c b/drivers/scsi/libsas/sas_expander.c index ccdb9d5e2f28..12886f96b286 100644 --- a/drivers/scsi/libsas/sas_expander.c +++ b/drivers/scsi/libsas/sas_expander.c @@ -282,6 +282,7 @@ static void sas_set_ex_phy(struct domain_device *dev, int phy_id, void *rsp) phy->phy->minimum_linkrate = dr->pmin_linkrate; phy->phy->maximum_linkrate = dr->pmax_linkrate; phy->phy->negotiated_linkrate = phy->linkrate; + phy->phy->enabled = (phy->linkrate != SAS_PHY_DISABLED); skip: if (new_phy) -- 2.14.1