3.11-stable review patch. If anyone has any objections, please let me know. ------------------ From: Nishanth Menon <nm@xxxxxx> commit bf00ca35cec8f0894dcfd90f88b03af1d5c7b86f upstream. As documented in Application Note SWPA117 v2.1(NDA), LDO override has a requirement that when switching from Bias active + override active mode(FBB/RBB) to Bypass(nominal) mode, LDO reset must be performed *after* LDO transitions to Bypass(nominal) mode. The same rule in reverse applies when switching from a ABB bypass mode to ABB enabled - LDO override *must* be performed prior to transition to required ABB mode, if we do not do that, the same glitch takes place. Currently while transitioning to ABB bypass, we reset the LDO overide prior to the transition which causes a few milliseconds where ABB LDO voltage could go all the way to 800mV(based on SoC process node), during this period, the delta voltage between VDD rail and VBB rail could cause the system to improperly function. Signed-off-by: Nishanth Menon <nm@xxxxxx> Signed-off-by: Mark Brown <broonie@xxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/regulator/ti-abb-regulator.c | 16 ++++++++++++++-- 1 file changed, 14 insertions(+), 2 deletions(-) --- a/drivers/regulator/ti-abb-regulator.c +++ b/drivers/regulator/ti-abb-regulator.c @@ -279,8 +279,12 @@ static int ti_abb_set_opp(struct regulat ti_abb_rmw(regs->opp_sel_mask, info->opp_sel, regs->control_reg, abb->base); - /* program LDO VBB vset override if needed */ - if (abb->ldo_base) + /* + * program LDO VBB vset override if needed for !bypass mode + * XXX: Do not switch sequence - for !bypass, LDO override reset *must* + * be performed *before* switch to bias mode else VBB glitches. + */ + if (abb->ldo_base && info->opp_sel != TI_ABB_NOMINAL_OPP) ti_abb_program_ldovbb(dev, abb, info); /* Initiate ABB ldo change */ @@ -295,6 +299,14 @@ static int ti_abb_set_opp(struct regulat if (ret) goto out; + /* + * Reset LDO VBB vset override bypass mode + * XXX: Do not switch sequence - for bypass, LDO override reset *must* + * be performed *after* switch to bypass else VBB glitches. + */ + if (abb->ldo_base && info->opp_sel == TI_ABB_NOMINAL_OPP) + ti_abb_program_ldovbb(dev, abb, info); + out: return ret; } -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html