Number of ECC status registers i.e. (ECCSTATx) has been increased in IFC version 2.0.0 due to increase in SRAM size. This is causing eccstat array to over flow. So, replace eccstat array with u32 variable to make it fail-safe and independent of number of ECC status registers or SRAM size. Cc: stable@xxxxxxxxxxxxxxx Signed-off-by: Prabhakar Kushwaha <prabhakar.kushwaha@xxxxxxx> Signed-off-by: Jagdish Gediya <jagdish.gediya@xxxxxxx> --- Changes for v2: Incorporated comments from Miquel Raynal and Boris Brezillon - Updated patch subject - Remove usage of eccstat array - Added Cc: stable@xxxxxxxxxxxxxxx drivers/mtd/nand/fsl_ifc_nand.c | 23 +++++++++++++---------- 1 file changed, 13 insertions(+), 10 deletions(-) diff --git a/drivers/mtd/nand/fsl_ifc_nand.c b/drivers/mtd/nand/fsl_ifc_nand.c index 4872a7b..d9ce398 100644 --- a/drivers/mtd/nand/fsl_ifc_nand.c +++ b/drivers/mtd/nand/fsl_ifc_nand.c @@ -173,14 +173,9 @@ static void set_addr(struct mtd_info *mtd, int column, int page_addr, int oob) /* returns nonzero if entire page is blank */ static int check_read_ecc(struct mtd_info *mtd, struct fsl_ifc_ctrl *ctrl, - u32 *eccstat, unsigned int bufnum) + u32 eccstat, unsigned int bufnum) { - u32 reg = eccstat[bufnum / 4]; - int errors; - - errors = (reg >> ((3 - bufnum % 4) * 8)) & 15; - - return errors; + return (eccstat >> ((3 - bufnum % 4) * 8)) & 15; } /* @@ -193,7 +188,7 @@ static void fsl_ifc_run_command(struct mtd_info *mtd) struct fsl_ifc_ctrl *ctrl = priv->ctrl; struct fsl_ifc_nand_ctrl *nctrl = ifc_nand_ctrl; struct fsl_ifc_runtime __iomem *ifc = ctrl->rregs; - u32 eccstat[4]; + u32 eccstat; int i; /* set the chip select for NAND Transaction */ @@ -237,10 +232,18 @@ static void fsl_ifc_run_command(struct mtd_info *mtd) else eccstat_regs = ifc->ifc_nand.v1_nand_eccstat; - for (i = sector / 4; i <= sector_end / 4; i++) - eccstat[i] = ifc_in32(&eccstat_regs[i]); + eccstat = 0; for (i = sector; i <= sector_end; i++) { + + /* + * if page size and sector size both are 512B then + * sector may not be multiple of 4 but sector and + * sector_end will be same. + */ + if ((i % 4 == 0) || (sector == sector_end)) + eccstat = ifc_in32(&eccstat_regs[i / 4]); + errors = check_read_ecc(mtd, ctrl, eccstat, i); if (errors == 15) { -- 1.9.1