4.15-stable review patch. If anyone has any objections, please let me know. ------------------ From: Adiel Aloni <adiel.aloni@xxxxxxxxx> [ Upstream commit e16ea4bb516bc21ea2202f2107718b29218bea59 ] Enforce using PS_MANUAL_POLL in ps hwsim debugfs to trigger a poll, only if PS_ENABLED was set before. This is required due to commit c9491367b759 ("mac80211: always update the PM state of a peer on MGMT / DATA frames") that enforces the ap to check only mgmt/data frames ps bit, and then update station's power save accordingly. When sending only ps-poll (control frame) the ap will not be aware that the station entered power save. Setting ps enable before triggering ps_poll, will send NDP with PM bit enabled first. Signed-off-by: Adiel Aloni <adiel.aloni@xxxxxxxxx> Signed-off-by: Luca Coelho <luciano.coelho@xxxxxxxxx> Signed-off-by: Johannes Berg <johannes.berg@xxxxxxxxx> Signed-off-by: Sasha Levin <alexander.levin@xxxxxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/net/wireless/mac80211_hwsim.c | 17 +++++++++++------ 1 file changed, 11 insertions(+), 6 deletions(-) --- a/drivers/net/wireless/mac80211_hwsim.c +++ b/drivers/net/wireless/mac80211_hwsim.c @@ -729,16 +729,21 @@ static int hwsim_fops_ps_write(void *dat val != PS_MANUAL_POLL) return -EINVAL; - old_ps = data->ps; - data->ps = val; - - local_bh_disable(); if (val == PS_MANUAL_POLL) { + if (data->ps != PS_ENABLED) + return -EINVAL; + local_bh_disable(); ieee80211_iterate_active_interfaces_atomic( data->hw, IEEE80211_IFACE_ITER_NORMAL, hwsim_send_ps_poll, data); - data->ps_poll_pending = true; - } else if (old_ps == PS_DISABLED && val != PS_DISABLED) { + local_bh_enable(); + return 0; + } + old_ps = data->ps; + data->ps = val; + + local_bh_disable(); + if (old_ps == PS_DISABLED && val != PS_DISABLED) { ieee80211_iterate_active_interfaces_atomic( data->hw, IEEE80211_IFACE_ITER_NORMAL, hwsim_send_nullfunc_ps, data);