Op 13-03-18 om 10:40 schreef Chris Wilson: > Quoting Maarten Lankhorst (2018-03-13 09:28:55) >> On fi-cnl-y3 we have 2 modes that differ only by crtc_clock. This means >> that if we request the normal mode, we automatically get the downclocked >> mode. >> >> This can be seen during boot: >> [drm:drm_helper_probe_single_connector_modes] [CONNECTOR:101:eDP-1] probed modes : >> [drm:drm_mode_debug_printmodeline] Modeline 102:"3840x2160" 60 533250 3840 3888 3920 4000 2160 2163 2168 2222 0x48 0xa >> [drm:drm_mode_debug_printmodeline] Modeline 103:"3840x2160" 48 426600 3840 3888 3920 4000 2160 2163 2168 2222 0x40 0xa >> ... >> [drm:intel_dump_pipe_config [i915]] [CRTC:51:pipe A][modeset] >> [drm:intel_dump_pipe_config [i915]] output_types: EDP (0x100) >> [drm:intel_dump_pipe_config [i915]] cpu_transcoder: EDP, pipe bpp: 24, dithering: 0 >> [drm:intel_dump_pipe_config [i915]] dp m_n: lanes: 4; gmch_m: 4970250, gmch_n: 8388608, link_m: 828375, link_n: 1048576, tu: 64 >> [drm:intel_dump_pipe_config [i915]] dp m2_n2: lanes: 4; gmch_m: 4970250, gmch_n: 8388608, link_m: 828375, link_n: 1048576, tu: 64 >> [drm:intel_dump_pipe_config [i915]] audio: 0, infoframes: 0 >> [drm:intel_dump_pipe_config [i915]] requested mode: >> [drm:drm_mode_debug_printmodeline] Modeline 0:"3840x2160" 60 533250 3840 3888 3920 4000 2160 2163 2168 2222 0x48 0xa >> [drm:intel_dump_pipe_config [i915]] adjusted mode: >> [drm:drm_mode_debug_printmodeline] Modeline 0:"3840x2160" 48 426600 3840 3888 3920 4000 2160 2163 2168 2222 0x40 0xa > Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=105469 > ? Yes, also References: https://bugs.freedesktop.org/show_bug.cgi?id=105456 Since that's how I found out..