From: Mikhail Lappo <mikhail.lappo@xxxxxxxxxxx>
When device boots with T > T_trip_1 and requests interrupt,
the race condition takes place. The interrupt comes before
THERMAL_DEVICE_ENABLED is set. This leads to an attempt to
reading sensor value from irq and disabling the sensor, based on
the data->mode field, which expected to be THERMAL_DEVICE_ENABLED,
but still stays as THERMAL_DEVICE_DISABLED. Afher this issue
sensor is never re-enabled, as the driver state is wrong.
Fix this problem by setting the 'data' members prior to
requesting the interrupts.
Fixes: 37713a1e8e4c ("thermal: imx: implement thermal alarm interrupt handling")
Cc: <stable@xxxxxxxxxxxxxxx>
Signed-off-by: Mikhail Lappo <mikhail.lappo@xxxxxxxxxxx>
Signed-off-by: Fabio Estevam <fabio.estevam@xxxxxxx>
---
drivers/thermal/imx_thermal.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/thermal/imx_thermal.c b/drivers/thermal/imx_thermal.c
index a67781b..ee3a215 100644
--- a/drivers/thermal/imx_thermal.c
+++ b/drivers/thermal/imx_thermal.c
@@ -637,6 +637,9 @@ static int imx_thermal_probe(struct platform_device *pdev)
regmap_write(map, TEMPSENSE0 + REG_CLR, TEMPSENSE0_POWER_DOWN);
regmap_write(map, TEMPSENSE0 + REG_SET, TEMPSENSE0_MEASURE_TEMP);
+ data->irq_enabled = true;
+ data->mode = THERMAL_DEVICE_ENABLED;
+
ret = devm_request_threaded_irq(&pdev->dev, data->irq,
imx_thermal_alarm_irq, imx_thermal_alarm_irq_thread,
0, "imx_thermal", data);
@@ -649,9 +652,6 @@ static int imx_thermal_probe(struct platform_device *pdev)
return ret;
}
- data->irq_enabled = true;
- data->mode = THERMAL_DEVICE_ENABLED;
-
return 0;
}
--
2.7.4