From: Ray Jui <ray.jui@xxxxxxxxxxxx> [ Upstream commit a7f3f939dd7d8398acebecd1ceb2e9e7ffbe91d2 ] The current 'bnxt_shutdown' implementation only invokes 'bnxt_ulp_shutdown' to shut down RoCE in the case when the system is in the path of power off (SYSTEM_POWER_OFF). While this may work in most cases, it does not work in the smart NIC case, when Linux 'reboot' command is initiated from the Linux that runs on the ARM cores of the NIC card. In this particular case, Linux 'reboot' results in a system 'L3' level reset where the entire ARM and associated subsystems are being reset, but at the same time, Nitro core is being kept in sane state (to allow external PCIe connected servers to continue to work). Without properly shutting down RoCE and freeing all associated resources, it results in the ARM core to hang immediately after the 'reboot' By always invoking 'bnxt_ulp_shutdown' in 'bnxt_shutdown', it fixes the above issue Fixes: 0efd2fc65c92 ("bnxt_en: Add a callback to inform RDMA driver during PCI shutdown.") Signed-off-by: Ray Jui <ray.jui@xxxxxxxxxxxx> Signed-off-by: Michael Chan <michael.chan@xxxxxxxxxxxx> Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx> Signed-off-by: Sasha Levin <alexander.levin@xxxxxxxxxxxxx> --- drivers/net/ethernet/broadcom/bnxt/bnxt.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/ethernet/broadcom/bnxt/bnxt.c b/drivers/net/ethernet/broadcom/bnxt/bnxt.c index aa764c5e3c6b..b66689a6eac0 100644 --- a/drivers/net/ethernet/broadcom/bnxt/bnxt.c +++ b/drivers/net/ethernet/broadcom/bnxt/bnxt.c @@ -8218,8 +8218,9 @@ static void bnxt_shutdown(struct pci_dev *pdev) if (netif_running(dev)) dev_close(dev); + bnxt_ulp_shutdown(bp); + if (system_state == SYSTEM_POWER_OFF) { - bnxt_ulp_shutdown(bp); bnxt_clear_int_mode(bp); pci_wake_from_d3(pdev, bp->wol); pci_set_power_state(pdev, PCI_D3hot); -- 2.11.0