This is a note to let you know that I've just added the patch titled
net: fec: Allow reception of frames bigger than 1522 bytes
to the 4.9-stable tree which can be found at:
http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary
The filename of the patch is:
net-fec-allow-reception-of-frames-bigger-than-1522-bytes.patch
and it can be found in the queue-4.9 subdirectory.
If you, or anyone else, feels it should not be added to the stable tree,
please let <stable@xxxxxxxxxxxxxxx> know about it.
>From foo@baz Sun Dec 31 11:13:15 CET 2017
From: Andrew Lunn <andrew@xxxxxxx>
Date: Sun, 30 Jul 2017 19:36:05 +0200
Subject: net: fec: Allow reception of frames bigger than 1522 bytes
From: Andrew Lunn <andrew@xxxxxxx>
[ Upstream commit fbbeefdd21049fcf9437c809da3828b210577f36 ]
The FEC Receive Control Register has a 14 bit field indicating the
longest frame that may be received. It is being set to 1522. Frames
longer than this are discarded, but counted as being in error.
When using DSA, frames from the switch has an additional header,
either 4 or 8 bytes if a Marvell switch is used. Thus a full MTU frame
of 1522 bytes received by the switch on a port becomes 1530 bytes when
passed to the host via the FEC interface.
Change the maximum receive size to 2048 - 64, where 64 is the maximum
rx_alignment applied on the receive buffer for AVB capable FEC
cores. Use this value also for the maximum receive buffer size. The
driver is already allocating a receive SKB of 2048 bytes, so this
change should not have any significant effects.
Tested on imx51, imx6, vf610.
Signed-off-by: Andrew Lunn <andrew@xxxxxxx>
Signed-off-by: David S. Miller <davem@xxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/net/ethernet/freescale/fec_main.c | 8 +++++---
1 file changed, 5 insertions(+), 3 deletions(-)
--- a/drivers/net/ethernet/freescale/fec_main.c
+++ b/drivers/net/ethernet/freescale/fec_main.c
@@ -172,10 +172,12 @@ MODULE_PARM_DESC(macaddr, "FEC Ethernet
#endif /* CONFIG_M5272 */
/* The FEC stores dest/src/type/vlan, data, and checksum for receive packets.
+ *
+ * 2048 byte skbufs are allocated. However, alignment requirements
+ * varies between FEC variants. Worst case is 64, so round down by 64.
*/
-#define PKT_MAXBUF_SIZE 1522
+#define PKT_MAXBUF_SIZE (round_down(2048 - 64, 64))
#define PKT_MINBUF_SIZE 64
-#define PKT_MAXBLR_SIZE 1536
/* FEC receive acceleration */
#define FEC_RACC_IPDIS (1 << 1)
@@ -853,7 +855,7 @@ static void fec_enet_enable_ring(struct
for (i = 0; i < fep->num_rx_queues; i++) {
rxq = fep->rx_queue[i];
writel(rxq->bd.dma, fep->hwp + FEC_R_DES_START(i));
- writel(PKT_MAXBLR_SIZE, fep->hwp + FEC_R_BUFF_SIZE(i));
+ writel(PKT_MAXBUF_SIZE, fep->hwp + FEC_R_BUFF_SIZE(i));
/* enable DMA1/2 */
if (i)
Patches currently in stable-queue which might be from andrew@xxxxxxx are
queue-4.9/net-igmp-use-correct-source-address-on-igmpv3-reports.patch
queue-4.9/net-mvmdio-disable-unprepare-clocks-in-eprobe_defer-case.patch
queue-4.9/net-fec-allow-reception-of-frames-bigger-than-1522-bytes.patch