BCM43341 devices soldered onto the PCB (non-removable) always (AFAICT) use an UART connection for bluetooth. But they also advertise btsdio support on their 3th sdio function, this causes 2 problems: 1) A non functioning BT HCI getting registered 2) Since the btsdio driver does not have suspend/resume callbacks, mmc_sdio_pre_suspend will return -ENOSYS, causing mmc_pm_notify() to react as if the SDIO-card is removed and since the slot is marked as non-removable it will never get detected as inserted again. Which results in wifi no longer working after a suspend/resume. This commit fixes both by making btsdio ignore BCM43341 devices when connected to a slot which is marked non-removable. Cc: stable@xxxxxxxxxxxxxxx Signed-off-by: Hans de Goede <hdegoede@xxxxxxxxxx> --- drivers/bluetooth/btsdio.c | 10 ++++++++++ 1 file changed, 10 insertions(+) diff --git a/drivers/bluetooth/btsdio.c b/drivers/bluetooth/btsdio.c index c8e945d19ffe..76c1405c7242 100644 --- a/drivers/bluetooth/btsdio.c +++ b/drivers/bluetooth/btsdio.c @@ -31,6 +31,7 @@ #include <linux/errno.h> #include <linux/skbuff.h> +#include <linux/mmc/host.h> #include <linux/mmc/sdio_ids.h> #include <linux/mmc/sdio_func.h> @@ -292,6 +293,15 @@ static int btsdio_probe(struct sdio_func *func, tuple = tuple->next; } + /* + * BCM43341 devices soldered onto the PCB (non-removable) use an + * uart connection for bluetooth, ignore the BT SDIO interface. + */ + if (func->vendor == SDIO_VENDOR_ID_BROADCOM && + func->device == SDIO_DEVICE_ID_BROADCOM_43341 && + !mmc_card_is_removable(func->card->host)) + return -ENODEV; + data = devm_kzalloc(&func->dev, sizeof(*data), GFP_KERNEL); if (!data) return -ENOMEM; -- 2.14.3