On Wed, Nov 08, 2017 at 12:17:28PM -0800, Eric Anholt wrote: > Ville Syrjala <ville.syrjala@xxxxxxxxxxxxxxx> writes: > > > From: Ville Syrjälä <ville.syrjala@xxxxxxxxxxxxxxx> > > > > Apparently some sinks look at the YQ bits even when receiving RGB, > > and they get somehow confused when they see a non-zero YQ value. > > So we can't just blindly follow CEA-861-F and set YQ to match the > > RGB range. > > > > Unfortunately there is no good way to tell whether the sink > > designer claims to have read CEA-861-F. The CEA extension block > > revision number has generally been stuck at 3 since forever, > > and even a very recently manufactured sink might be based on > > an old design so the manufacturing date doesn't seem like > > something we can use. In lieu of better information let's > > follow CEA-861-F only for HDMI 2.0 sinks, since HDMI 2.0 is > > based on CEA-861-F. For HDMI 1.x sinks we'll always set YQ=0. > > > > The alternative would of course be to always set YQ=0. And if > > we ever encounter a HDMI 2.0+ sink with this bug that's what > > we'll probably have to do. > > Should vc4 be doing anything special for HDMI2 sinks, if it's an HDMI1.4 > source? As long as you stick to < 340 MHz modes you shouldn't have to do anything. For >=340 MHz you'd need to use some new HDMI 2.0 features. Looks like vc4 crtc .mode_valid() doesn't do much. I presume it's up to bridges/encoders to filter out most things that aren't supported? > > That said, as far as vc4, this patch is > > Acked-by: Eric Anholt <eric@xxxxxxxxxx> Ta. -- Ville Syrjälä Intel OTC