On Wed, Sep 04, 2013 at 04:21:18PM +0200, Thomas Petazzoni wrote: > This commit fixes a long-standing bug that has been reported by many > users: on some Armada 370 platforms, only the network interface that > has been used in U-Boot to tftp the kernel works properly in > Linux. The other network interfaces can see a 'link up', but are > unable to transmit data. The reports were generally made on the Armada > 370-based Mirabox, but have also been given on the Armada 370-RD > board. > > The network MAC in the Armada 370/XP (supported by the mvneta driver > in Linux) has a functionality that allows it to continuously poll the > PHY and directly update the MAC configuration accordingly (speed, > duplex, etc.). The very first versions of the driver submitted for > review were using this hardware mechanism, but due to this, the driver > was not integrated with the kernel phylib. Following reviews, the > driver was changed to use the phylib, and therefore a software based > polling. In software based polling, Linux regularly talks to the PHY > over the MDIO bus, and sees if the link status has changed. If it's > the case then the adjust_link() callback of the driver is called to > update the MAC configuration accordingly. > > However, it turns out that the adjust_link() callback was not > configuring the hardware in a completely correct way: while it was > setting the speed and duplex bits correctly, it wasn't telling the > hardware to actually take into account those bits rather than what the > hardware-based PHY polling mechanism has concluded. So, in fact the > adjust_link() callback was basically a no-op. > > However, the network happened to be working because on the network > interfaces used by U-Boot for tftp on Armada 370 platforms because the > hardware PHY polling was enabled by the bootloader, and left enabled > by Linux. However, the second network interface not used for tftp (or > both network interfaces if the kernel is loaded from USB, NAND or SD > card) didn't had the hardware PHY polling enabled. > > This patch fixes this situation by: > > (1) Making sure that the hardware PHY polling is disabled by clearing > the MVNETA_PHY_POLLING_ENABLE bit in the MVNETA_UNIT_CONTROL > register in the driver ->probe() function. > > (2) Making sure that the duplex and speed selections made by the > adjust_link() callback are taken into account by clearing the > MVNETA_GMAC_AN_SPEED_EN and MVNETA_GMAC_AN_DUPLEX_EN bits in the > MVNETA_GMAC_AUTONEG_CONFIG register. > > This patch has been tested on Armada 370 Mirabox, and now both network > interfaces are usable after boot. > > Signed-off-by: Thomas Petazzoni <thomas.petazzoni@xxxxxxxxxxxxxxxxxx> > Cc: Willy Tarreau <w@xxxxxx> > Cc: Jochen De Smet <jochen.armkernel@xxxxxxxxxxx> > Cc: Peter Sanford <psanford@xxxxxxxxxx> > Cc: Ethan Tuttle <ethan@xxxxxxxxxxxxxxx> > Cc: Chény Yves-Gael <yves@xxxxxxxx> > Cc: Ryan Press <ryan@xxxxxxxxxxx> > Cc: Simon Guinot <simon.guinot@xxxxxxxxxxxx> > Cc: vdonnefort@xxxxxxxxx > Cc: stable@xxxxxxxxxxxxxxx > --- > David, this patch is a fix for a problem that has been here since 3.8 > (when the mvneta driver was introduced), so I've Cc'ed stable@ and if > possible I'd like to patch to be included for 3.12. David, Offending patch is: c5aff18 net: mvneta: driver for Marvell Armada 370/XP network unit Applies and builds cleanly against v3.8.13, v3.9.11, v3.10.10, and v3.11 Acked-by: Jason Cooper <jason@xxxxxxxxxxxxxx> thx, Jason. > --- > drivers/net/ethernet/marvell/mvneta.c | 13 ++++++++++++- > 1 file changed, 12 insertions(+), 1 deletion(-) > > diff --git a/drivers/net/ethernet/marvell/mvneta.c b/drivers/net/ethernet/marvell/mvneta.c > index b017818..90ab292 100644 > --- a/drivers/net/ethernet/marvell/mvneta.c > +++ b/drivers/net/ethernet/marvell/mvneta.c > @@ -138,7 +138,9 @@ > #define MVNETA_GMAC_FORCE_LINK_PASS BIT(1) > #define MVNETA_GMAC_CONFIG_MII_SPEED BIT(5) > #define MVNETA_GMAC_CONFIG_GMII_SPEED BIT(6) > +#define MVNETA_GMAC_AN_SPEED_EN BIT(7) > #define MVNETA_GMAC_CONFIG_FULL_DUPLEX BIT(12) > +#define MVNETA_GMAC_AN_DUPLEX_EN BIT(13) > #define MVNETA_MIB_COUNTERS_BASE 0x3080 > #define MVNETA_MIB_LATE_COLLISION 0x7c > #define MVNETA_DA_FILT_SPEC_MCAST 0x3400 > @@ -915,6 +917,13 @@ static void mvneta_defaults_set(struct mvneta_port *pp) > /* Assign port SDMA configuration */ > mvreg_write(pp, MVNETA_SDMA_CONFIG, val); > > + /* Disable PHY polling in hardware, since we're using the > + * kernel phylib to do this. > + */ > + val = mvreg_read(pp, MVNETA_UNIT_CONTROL); > + val &= ~MVNETA_PHY_POLLING_ENABLE; > + mvreg_write(pp, MVNETA_UNIT_CONTROL, val); > + > mvneta_set_ucast_table(pp, -1); > mvneta_set_special_mcast_table(pp, -1); > mvneta_set_other_mcast_table(pp, -1); > @@ -2307,7 +2316,9 @@ static void mvneta_adjust_link(struct net_device *ndev) > val = mvreg_read(pp, MVNETA_GMAC_AUTONEG_CONFIG); > val &= ~(MVNETA_GMAC_CONFIG_MII_SPEED | > MVNETA_GMAC_CONFIG_GMII_SPEED | > - MVNETA_GMAC_CONFIG_FULL_DUPLEX); > + MVNETA_GMAC_CONFIG_FULL_DUPLEX | > + MVNETA_GMAC_AN_SPEED_EN | > + MVNETA_GMAC_AN_DUPLEX_EN); > > if (phydev->duplex) > val |= MVNETA_GMAC_CONFIG_FULL_DUPLEX; > -- > 1.8.1.2 > > > _______________________________________________ > linux-arm-kernel mailing list > linux-arm-kernel@xxxxxxxxxxxxxxxxxxx > http://lists.infradead.org/mailman/listinfo/linux-arm-kernel -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html