4.12-stable review patch. If anyone has any objections, please let me know. ------------------ From: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx> commit 2acecd58969897795cf015c9057ebd349a3fda8a upstream. The latest HW manual (Rev.0.55) shows us this UGCTRL2.VBUSSEL bit. If the bit sets to 1, the VBUS drive is controlled by phy related registers (called "UCOM Registers" on the manual). Since R-Car Gen3 environment will control VBUS by phy-rcar-gen3-usb2 driver, the UGCTRL2.VBUSSEL bit should be set to 1. So, this patch fixes the register's value. Otherwise, even if the ID pin indicates to peripheral, the R-Car will output USBn_PWEN to 1 when a host driver is running. Fixes: de18757e272d ("usb: renesas_usbhs: add R-Car Gen3 power control" Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx> Signed-off-by: Felipe Balbi <felipe.balbi@xxxxxxxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/usb/renesas_usbhs/rcar3.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) --- a/drivers/usb/renesas_usbhs/rcar3.c +++ b/drivers/usb/renesas_usbhs/rcar3.c @@ -20,9 +20,13 @@ /* Low Power Status register (LPSTS) */ #define LPSTS_SUSPM 0x4000 -/* USB General control register 2 (UGCTRL2), bit[31:6] should be 0 */ +/* + * USB General control register 2 (UGCTRL2) + * Remarks: bit[31:11] and bit[9:6] should be 0 + */ #define UGCTRL2_RESERVED_3 0x00000001 /* bit[3:0] should be B'0001 */ #define UGCTRL2_USB0SEL_OTG 0x00000030 +#define UGCTRL2_VBUSSEL 0x00000400 static void usbhs_write32(struct usbhs_priv *priv, u32 reg, u32 data) { @@ -34,7 +38,8 @@ static int usbhs_rcar3_power_ctrl(struct { struct usbhs_priv *priv = usbhs_pdev_to_priv(pdev); - usbhs_write32(priv, UGCTRL2, UGCTRL2_RESERVED_3 | UGCTRL2_USB0SEL_OTG); + usbhs_write32(priv, UGCTRL2, UGCTRL2_RESERVED_3 | UGCTRL2_USB0SEL_OTG | + UGCTRL2_VBUSSEL); if (enable) { usbhs_bset(priv, LPSTS, LPSTS_SUSPM, LPSTS_SUSPM);