From: YD Tseng <yd_tseng@xxxxxxxxxxxxxx> xHCI host controllers can have both USB 3.1 and 3.0 extended speed protocol lists. If the USB3.1 speed is parsed first and 3.0 second then the minor revision supported will be overwritten by the 3.0 speeds and the USB3 roothub will only show support for USB 3.0 speeds. This was the case with a xhci controller with the supported protocol capability listed below. In xhci-mem.c, the USB 3.1 speed is parsed first, the min_rev of usb3_rhub is set as 0x10. And then USB 3.0 is parsed. However, the min_rev of usb3_rhub will be changed to 0x00. If USB 3.1 device is connected behind this host controller, the speed of USB 3.1 device just reports 5G speed using lsusb. 00 01 02 03 04 05 06 07 08 09 0A 0B 0C 0D 0E 0F 00 01 08 00 00 00 00 00 40 00 00 00 00 00 00 00 00 10 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 20 02 08 10 03 55 53 42 20 01 02 00 00 00 00 00 00 //USB 3.1 30 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 40 02 08 00 03 55 53 42 20 03 06 00 00 00 00 00 00 //USB 3.0 50 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 60 02 08 00 02 55 53 42 20 09 0E 19 00 00 00 00 00 //USB 2.0 70 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 This patch fixes the issue by only owerwriting the minor revision if it is higher than the existing one. [reword commit message -Mathias] Cc: <stable@xxxxxxxxxxxxxxx> Signed-off-by: YD Tseng <yd_tseng@xxxxxxxxxxxxxx> Signed-off-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx> --- drivers/usb/host/xhci-mem.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) diff --git a/drivers/usb/host/xhci-mem.c b/drivers/usb/host/xhci-mem.c index 1f1687e..fddf273 100644 --- a/drivers/usb/host/xhci-mem.c +++ b/drivers/usb/host/xhci-mem.c @@ -2119,11 +2119,12 @@ static void xhci_add_in_port(struct xhci_hcd *xhci, unsigned int num_ports, { u32 temp, port_offset, port_count; int i; - u8 major_revision; + u8 major_revision, minor_revision; struct xhci_hub *rhub; temp = readl(addr); major_revision = XHCI_EXT_PORT_MAJOR(temp); + minor_revision = XHCI_EXT_PORT_MINOR(temp); if (major_revision == 0x03) { rhub = &xhci->usb3_rhub; @@ -2137,7 +2138,9 @@ static void xhci_add_in_port(struct xhci_hcd *xhci, unsigned int num_ports, return; } rhub->maj_rev = XHCI_EXT_PORT_MAJOR(temp); - rhub->min_rev = XHCI_EXT_PORT_MINOR(temp); + + if (rhub->min_rev < minor_revision) + rhub->min_rev = minor_revision; /* Port offset and count in the third dword, see section 7.2 */ temp = readl(addr + 2); -- 1.9.1