4.10-stable review patch. If anyone has any objections, please let me know. ------------------ From: Quentin Schulz <quentin.schulz@xxxxxxxxxxxxxxxxxx> commit 4bdc9029685ac03be50b320b29691766d2326c2b upstream. The gyroscope chip might need to be reset to be used. Without the chip being reset, the driver stopped at the first regmap_read (to get the CHIP_ID) and failed to probe. The datasheet of the gyroscope says that a minimum wait of 30ms after the reset has to be done. This patch has been checked on a BMX055 and the datasheet of the BMG160 and the BMI055 give the same reset register and bits. Signed-off-by: Quentin Schulz <quentin.schulz@xxxxxxxxxxxxxxxxxx> Signed-off-by: Jonathan Cameron <jic23@xxxxxxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/iio/gyro/bmg160_core.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) --- a/drivers/iio/gyro/bmg160_core.c +++ b/drivers/iio/gyro/bmg160_core.c @@ -27,6 +27,7 @@ #include <linux/iio/trigger_consumer.h> #include <linux/iio/triggered_buffer.h> #include <linux/regmap.h> +#include <linux/delay.h> #include "bmg160.h" #define BMG160_IRQ_NAME "bmg160_event" @@ -52,6 +53,9 @@ #define BMG160_DEF_BW 100 #define BMG160_REG_PMU_BW_RES BIT(7) +#define BMG160_GYRO_REG_RESET 0x14 +#define BMG160_GYRO_RESET_VAL 0xb6 + #define BMG160_REG_INT_MAP_0 0x17 #define BMG160_INT_MAP_0_BIT_ANY BIT(1) @@ -236,6 +240,14 @@ static int bmg160_chip_init(struct bmg16 int ret; unsigned int val; + /* + * Reset chip to get it in a known good state. A delay of 30ms after + * reset is required according to the datasheet. + */ + regmap_write(data->regmap, BMG160_GYRO_REG_RESET, + BMG160_GYRO_RESET_VAL); + usleep_range(30000, 30700); + ret = regmap_read(data->regmap, BMG160_REG_CHIP_ID, &val); if (ret < 0) { dev_err(dev, "Error reading reg_chip_id\n");