4.10-stable review patch. If anyone has any objections, please let me know.
------------------
From: Tamizh chelvam <c_traja@xxxxxxxxxxxxxxxx>
commit cb4281528b62207918b1e95827cad7527aa4dbaa upstream.
Rx filter reset and the dynamic tx switch mode (EXT_RESOURCE_CFG)
configuration are causing the following errors when UTF firmware
is loaded to the target.
Error message 1:
[ 598.015629] ath10k_pci 0001:01:00.0: failed to ping firmware: -110
[ 598.020828] ath10k_pci 0001:01:00.0: failed to reset rx filter: -110
[ 598.141556] ath10k_pci 0001:01:00.0: failed to start core (testmode): -110
Error message 2:
[ 668.615839] ath10k_ahb a000000.wifi: failed to send ext resource cfg command : -95
[ 668.618902] ath10k_ahb a000000.wifi: failed to start core (testmode): -95
Avoiding these configurations while bringing the target in
testmode is solving the problem.
Signed-off-by: Tamizh chelvam <c_traja@xxxxxxxxxxxxxxxx>
Signed-off-by: Kalle Valo <kvalo@xxxxxxxxxxxxxxxx>
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/net/wireless/ath/ath10k/core.c | 14 +++++++++-----
1 file changed, 9 insertions(+), 5 deletions(-)
--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -1913,7 +1913,8 @@ int ath10k_core_start(struct ath10k *ar,
ath10k_dbg(ar, ATH10K_DBG_BOOT, "firmware %s booted\n",
ar->hw->wiphy->fw_version);
- if (test_bit(WMI_SERVICE_EXT_RES_CFG_SUPPORT, ar->wmi.svc_map)) {
+ if (test_bit(WMI_SERVICE_EXT_RES_CFG_SUPPORT, ar->wmi.svc_map) &&
+ mode == ATH10K_FIRMWARE_MODE_NORMAL) {
val = 0;
if (ath10k_peer_stats_enabled(ar))
val = WMI_10_4_PEER_STATS;
@@ -1966,10 +1967,13 @@ int ath10k_core_start(struct ath10k *ar,
* possible to implicitly make it correct by creating a dummy vdev and
* then deleting it.
*/
- status = ath10k_core_reset_rx_filter(ar);
- if (status) {
- ath10k_err(ar, "failed to reset rx filter: %d\n", status);
- goto err_hif_stop;
+ if (mode == ATH10K_FIRMWARE_MODE_NORMAL) {
+ status = ath10k_core_reset_rx_filter(ar);
+ if (status) {
+ ath10k_err(ar,
+ "failed to reset rx filter: %d\n", status);
+ goto err_hif_stop;
+ }
}
/* If firmware indicates Full Rx Reorder support it must be used in a