commit 43db289d00c6 ("gpio: stmpe: Rework registers access")
reworked the STMPE register access so as to use
[STMPE_IDX_*_LSB + i] to access the 8bit register for a
certain bank, assuming the CSB and MSB will follow after
the enumerator. For this to work the index needs to go from
(size-1) to 0 not 0 to (size-1).
However for the GPIO IRQ handler, the status registers we read
register MSB + 3 bytes ahead for the 24 bit GPIOs and index
registers from MSB upwards and run an index i over the
registers UNLESS we are STMPE1600.
This is not working when we get to clearing the interrupt
EDGE status register STMPE_IDX_GPEDR_[LCM]SB: it is indexed
like all other registers [STMPE_IDX_*_LSB + i] but in this
loop we index from 0 to get the right bank index for the
calculations, and we need to just add i to the MSB.
Before this, interrupts on the STMPE2401 were broken, this
patch fixes it so it works again.
Cc: stable@xxxxxxxxxxxxxxx
Cc: Patrice Chotard <patrice.chotard@xxxxxx>
Fixes: 43db289d00c6 ("gpio: stmpe: Rework registers access")
Signed-off-by: Linus Walleij <linus.walleij@xxxxxxxxxx>
---
drivers/gpio/gpio-stmpe.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c
index e7d422a6b90b..e2e1b16a42db 100644
--- a/drivers/gpio/gpio-stmpe.c
+++ b/drivers/gpio/gpio-stmpe.c
@@ -413,7 +413,7 @@ static irqreturn_t stmpe_gpio_irq(int irq, void *dev)
stmpe->partnum != STMPE1801) {
stmpe_reg_write(stmpe, statmsbreg + i, status[i]);
stmpe_reg_write(stmpe,
- stmpe->regs[STMPE_IDX_GPEDR_LSB + i],
+ stmpe->regs[STMPE_IDX_GPEDR_MSB] + i,
status[i]);
}
}
--
2.7.4
--
To unsubscribe from this list: send the line "unsubscribe stable" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html