3.10-stable review patch. If anyone has any objections, please let me know. ------------------ From: Roger Quadros <rogerq@xxxxxx> commit 4e5c9e6fa2d232a0686d5fe45cd1508484048936 upstream. For PHY mode, the PHYs must be brought out of reset before the EHCI controller is started. This patch fixes the issue where USB devices are not found on Beagleboard/Beagle-xm if USB has been started previously by the bootloader. (e.g. by "usb start" command in u-boot) Tested on Beagleboard, Beagleboard-xm and Pandaboard. Issue present on 3.10 onwards. Reported-by: Tomi Valkeinen <tomi.valkeinen@xxxxxx> Tested-by: Tomi Valkeinen <tomi.valkeinen@xxxxxx> Signed-off-by: Roger Quadros <rogerq@xxxxxx> Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> --- drivers/usb/host/ehci-omap.c | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-) --- a/drivers/usb/host/ehci-omap.c +++ b/drivers/usb/host/ehci-omap.c @@ -187,6 +187,12 @@ static int ehci_hcd_omap_probe(struct pl } omap->phy[i] = phy; + + if (pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) { + usb_phy_init(omap->phy[i]); + /* bring PHY out of suspend */ + usb_phy_set_suspend(omap->phy[i], 0); + } } pm_runtime_enable(dev); @@ -211,13 +217,14 @@ static int ehci_hcd_omap_probe(struct pl } /* - * Bring PHYs out of reset. + * Bring PHYs out of reset for non PHY modes. * Even though HSIC mode is a PHY-less mode, the reset * line exists between the chips and can be modelled * as a PHY device for reset control. */ for (i = 0; i < omap->nports; i++) { - if (!omap->phy[i]) + if (!omap->phy[i] || + pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) continue; usb_phy_init(omap->phy[i]); -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html