On Mon, Oct 10, 2016 at 09:11:23PM +0200, Mark Brown wrote: > On Mon, Oct 10, 2016 at 05:54:22AM -0700, Guenter Roeck wrote: > > > Can I find the qemu command line somewhere ? The following work fine > > for me. > > > Building arm:vexpress-a9:multi_v7_defconfig:vexpress-v2p-ca9 ... running ..... passed > > Building arm:vexpress-a15:multi_v7_defconfig:vexpress-v2p-ca15-tc1 ... running ..... passed > > Note that most of the failures my lab saw are with extra configs, the > only vanilla config that failed was vexpress-v2p-ca15_a7 with the > multi_v7_defconfig. > > My connection doesn't have IPv6 and is a bit spotty right now so it's a > bit difficult for me to check by lab but today's -next jobs are working > for me as well... looking at the log for the failed stable boots: > > https://storage.kernelci.org/stable/v4.8.1/arm-multi_v7_defconfig/lab-broonie/boot-vexpress-v2p-ca15_a7.html > > looks like it's some interaction with the test image causing udevadm > settle to not run quickly enough - there's also a big delay before the > UART comes up. I'm wondering if it's just that the host machine is just > too slow here. Can you send me (or point me to) the qemu command lines you are using ? Even better would the complete setup describing how you connect to kernelci. Thanks, Guenter -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html