From: Jes Sorensen <Jes.Sorensen@xxxxxxxxxx> The 8192eu suffered from two issues when reloading the driver. The same problems as with the 8723bu where REG_RX_WAIT_CCA bits 22 and 23 didn't get set in rtl8192e_enable_rf(). In addition it also seems prone to issues when setting REG_RF_CTRL to 0 intead of just disabling the RF_ENABLE bit. Similar to what was causing issues with the 8188eu. With this patch I can successfully reload the driver and reassociate to an APi with an 8192eu dongle. Signed-off-by: Jes Sorensen <Jes.Sorensen@xxxxxxxxxx> --- drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-) diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c index df54d27..a793fed 100644 --- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c +++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu_8192e.c @@ -1461,7 +1461,9 @@ static int rtl8192eu_active_to_emu(struct rtl8xxxu_priv *priv) int count, ret = 0; /* Turn off RF */ - rtl8xxxu_write8(priv, REG_RF_CTRL, 0); + val8 = rtl8xxxu_read8(priv, REG_RF_CTRL); + val8 &= ~RF_ENABLE; + rtl8xxxu_write8(priv, REG_RF_CTRL, val8); /* Switch DPDT_SEL_P output from register 0x65[2] */ val8 = rtl8xxxu_read8(priv, REG_LEDCFG2); @@ -1593,6 +1595,10 @@ static void rtl8192e_enable_rf(struct rtl8xxxu_priv *priv) u32 val32; u8 val8; + val32 = rtl8xxxu_read32(priv, REG_RX_WAIT_CCA); + val32 |= (BIT(22) | BIT(23)); + rtl8xxxu_write32(priv, REG_RX_WAIT_CCA, val32); + val8 = rtl8xxxu_read8(priv, REG_GPIO_MUXCFG); val8 |= BIT(5); rtl8xxxu_write8(priv, REG_GPIO_MUXCFG, val8); -- 2.7.4 -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html