+ stable On 30 August 2016 at 14:17, Daniel Glöckner <dg@xxxxxxxxx> wrote: > CMD23 aka SET_BLOCK_COUNT was introduced with MMC v3.1. > Older versions of the specification allowed to terminate > multi-block transfers only with CMD12. > > The patch fixes the following problem: > > mmc0: new MMC card at address 0001 > mmcblk0: mmc0:0001 SDMB-16 15.3 MiB > mmcblk0: timed out sending SET_BLOCK_COUNT command, card status 0x400900 > ... > blk_update_request: I/O error, dev mmcblk0, sector 0 > Buffer I/O error on dev mmcblk0, logical block 0, async page read > mmcblk0: unable to read partition table > > Signed-off-by: Daniel Glöckner <dg@xxxxxxxxx> This was an old problem you found, nice! I should remove the dust from my old MMC cards and give them a go with this change. I assume it could be worth to send this to stable as well, so I will add a stable tag to it. Applied for next! Thanks and kind regards! Uffe > --- > drivers/mmc/card/block.c | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > diff --git a/drivers/mmc/card/block.c b/drivers/mmc/card/block.c > index 2206d44..0fec40d 100644 > --- a/drivers/mmc/card/block.c > +++ b/drivers/mmc/card/block.c > @@ -2303,7 +2303,8 @@ again: > set_capacity(md->disk, size); > > if (mmc_host_cmd23(card->host)) { > - if (mmc_card_mmc(card) || > + if ((mmc_card_mmc(card) && > + card->csd.mmca_vsn >= CSD_SPEC_VER_3)|| > (mmc_card_sd(card) && > card->scr.cmds & SD_SCR_CMD23_SUPPORT)) > md->flags |= MMC_BLK_CMD23; > -- > 2.1.2 > -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html