The firmware of R-Car USB 3.0 host controller will control the reset.
So, if the xhci driver doesn't do firmware downloading (e.g. kernel
configuration is CONFIG_USB_XHCI_PLATFORM=y and CONFIG_USB_XHCI_RCAR
is not set), the reset of USB 3.0 host controller doesn't work
correctly. Then, the host controller will cause long wait in
xhci_reset() because the CMD_RESET bit of op_regs->command is not
cleared for 10 seconds.
So, this patch modifies the xhci_rcar_init_quirk() in xhci-rcar.h
to exit the probe function immediately.
Fixes: 4ac8918f3a7 (usb: host: xhci-plat: add support for the R-Car H2 and M2 xHCI controllers)
Cc: <stable@xxxxxxxxxxxxxxx> # v3.17+
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@xxxxxxxxxxx>
---
Changes from v1:
- Revise the commit log.
(http://www.spinics.net/lists/stable/msg130007.html)
drivers/usb/host/xhci-rcar.h | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)
diff --git a/drivers/usb/host/xhci-rcar.h b/drivers/usb/host/xhci-rcar.h
index 2941a25..2afed68 100644
--- a/drivers/usb/host/xhci-rcar.h
+++ b/drivers/usb/host/xhci-rcar.h
@@ -24,7 +24,11 @@ static inline void xhci_rcar_start(struct usb_hcd *hcd)
static inline int xhci_rcar_init_quirk(struct usb_hcd *hcd)
{
- return 0;
+ /*
+ * To avoid wait and timeout in xhci_reset() if CONFIG_XHCI_RCAR is
+ * disabled, this function fails.
+ */
+ return -ENODEV;
}
#endif
#endif /* _XHCI_RCAR_H */
--
1.9.1
--
To unsubscribe from this list: send the line "unsubscribe stable" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html