The LED can be active high instead of active low on some hardware. Add the led_active_high module parameter. It defaults to -1 to obey platform data as before. Setting the parameter to 1 or 0 will force the LED respectively active high or active low. Cc: <linux-wireless@xxxxxxxxxxxxxxx> Cc: <ath9k-devel@xxxxxxxxxxxxxxxx> Cc: <ath9k-devel@xxxxxxxxxxxxxxx> Cc: <stable@xxxxxxxxxxxxxxx> Signed-off-by: Vittorio Gambaletta <linuxbugs@xxxxxxxxxxx> --- --- a/drivers/net/wireless/ath/ath9k/init.c +++ b/drivers/net/wireless/ath/ath9k/init.c @@ -49,6 +49,10 @@ int ath9k_led_blink; module_param_named(blink, ath9k_led_blink, int, 0444); MODULE_PARM_DESC(blink, "Enable LED blink on activity"); +static int ath9k_led_active_high = -1; +module_param_named(led_active_high, ath9k_led_active_high, int, 0444); +MODULE_PARM_DESC(led_active_high, "Invert LED polarity"); + static int ath9k_btcoex_enable; module_param_named(btcoex_enable, ath9k_btcoex_enable, int, 0444); MODULE_PARM_DESC(btcoex_enable, "Enable wifi-BT coexistence"); @@ -600,6 +604,9 @@ static int ath9k_init_softc(u16 devid, struct ath_softc *sc, if (ret) return ret; + if (ath9k_led_active_high != -1) + ah->config.led_active_high = ath9k_led_active_high == 1; + /* * Enable WLAN/BT RX Antenna diversity only when: * -- To unsubscribe from this list: send the line "unsubscribe stable" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html