From: Prashanth K <quic_prashk@xxxxxxxxxxx>
commit c96e31252110a84dcc44412e8a7b456b33c3e298 upstream.
DWC3 programming guide mentions that when operating in USB2.0 speeds,
if GUSB2PHYCFG[6] or GUSB2PHYCFG[8] is set, it must be cleared prior
to issuing commands and may be set again after the command completes.
But currently while issuing EndXfer command without CmdIOC set, we
wait for 1ms after GUSB2PHYCFG is restored. This results in cases
where EndXfer command doesn't get completed and causes SMMU faults
since requests are unmapped afterwards. Hence restore GUSB2PHYCFG
after waiting for EndXfer command completion.
Cc: stable@xxxxxxxxxxxxxxx
Fixes: 1d26ba0944d3 ("usb: dwc3: Wait unconditionally after issuing EndXfer command")
Signed-off-by: Prashanth K <quic_prashk@xxxxxxxxxxx>
Acked-by: Thinh Nguyen <Thinh.Nguyen@xxxxxxxxxxxx>
Link: https://lore.kernel.org/r/20240924093208.2524531-1-quic_prashk@xxxxxxxxxxx
Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/usb/dwc3/gadget.c | 10 ++++++----
1 file changed, 6 insertions(+), 4 deletions(-)
--- a/drivers/usb/dwc3/gadget.c
+++ b/drivers/usb/dwc3/gadget.c
@@ -445,6 +445,10 @@ skip_status:
dwc3_gadget_ep_get_transfer_index(dep);
}
+ if (DWC3_DEPCMD_CMD(cmd) == DWC3_DEPCMD_ENDTRANSFER &&
+ !(cmd & DWC3_DEPCMD_CMDIOC))
+ mdelay(1);
+
if (saved_config) {
reg = dwc3_readl(dwc->regs, DWC3_GUSB2PHYCFG(0));
reg |= saved_config;
@@ -1731,12 +1735,10 @@ static int __dwc3_stop_active_transfer(s
WARN_ON_ONCE(ret);
dep->resource_index = 0;
- if (!interrupt) {
- mdelay(1);
+ if (!interrupt)
dep->flags &= ~DWC3_EP_TRANSFER_STARTED;
- } else if (!ret) {
+ else if (!ret)
dep->flags |= DWC3_EP_END_TRANSFER_PENDING;
- }
dep->flags &= ~DWC3_EP_DELAY_STOP;
return ret;
Patches currently in stable-queue which might be from quic_prashk@xxxxxxxxxxx are
queue-6.1/usb-dwc3-wait-for-endxfer-completion-before-restoring-gusb2phycfg.patch
