This is a note to let you know that I've just added the patch titled pwm: tegra: Improve required rate calculation to the 6.1-stable tree which can be found at: http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary The filename of the patch is: pwm-tegra-improve-required-rate-calculation.patch and it can be found in the queue-6.1 subdirectory. If you, or anyone else, feels it should not be added to the stable tree, please let <stable@xxxxxxxxxxxxxxx> know about it. commit 6c77ef91735cb7c0d421162b91facbbe0b9da4ce Author: Jon Hunter <jonathanh@xxxxxxxxxx> Date: Fri Oct 28 13:33:55 2022 +0100 pwm: tegra: Improve required rate calculation [ Upstream commit f271946117dde2ca8741b8138b347b2d68e6ad56 ] For the case where dev_pm_opp_set_rate() is called to set the PWM clock rate, the requested rate is calculated as ... required_clk_rate = (NSEC_PER_SEC / period_ns) << PWM_DUTY_WIDTH; The above calculation may lead to rounding errors because the NSEC_PER_SEC is divided by 'period_ns' before applying the PWM_DUTY_WIDTH multiplication factor. For example, if the period is 45334ns, the above calculation yields a rate of 5646848Hz instead of 5646976Hz. Fix this by applying the multiplication factor before dividing and using the DIV_ROUND_UP macro which yields the expected result of 5646976Hz. Fixes: 1d7796bdb63a ("pwm: tegra: Support dynamic clock frequency configuration") Signed-off-by: Jon Hunter <jonathanh@xxxxxxxxxx> Reviewed-by: Uwe Kleine-König <u.kleine-koenig@xxxxxxxxxxxxxx> Signed-off-by: Thierry Reding <thierry.reding@xxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> diff --git a/drivers/pwm/pwm-tegra.c b/drivers/pwm/pwm-tegra.c index dad9978c9186..b05ea2e8accc 100644 --- a/drivers/pwm/pwm-tegra.c +++ b/drivers/pwm/pwm-tegra.c @@ -145,8 +145,8 @@ static int tegra_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm, * source clock rate as required_clk_rate, PWM controller will * be able to configure the requested period. */ - required_clk_rate = - (NSEC_PER_SEC / period_ns) << PWM_DUTY_WIDTH; + required_clk_rate = DIV_ROUND_UP_ULL(NSEC_PER_SEC << PWM_DUTY_WIDTH, + period_ns); err = dev_pm_opp_set_rate(pc->dev, required_clk_rate); if (err < 0)