This is a note to let you know that I've just added the patch titled usb: dwc3: gadget: Disable GUSB2PHYCFG.SUSPHY for End Transfer to the 5.15-stable tree which can be found at: http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary The filename of the patch is: usb-dwc3-gadget-disable-gusb2phycfg.susphy-for-end-t.patch and it can be found in the queue-5.15 subdirectory. If you, or anyone else, feels it should not be added to the stable tree, please let <stable@xxxxxxxxxxxxxxx> know about it. commit 470b9634aa9a05ba13d926c96993581a8cf40842 Author: Thinh Nguyen <Thinh.Nguyen@xxxxxxxxxxxx> Date: Wed Nov 9 17:58:50 2022 -0800 usb: dwc3: gadget: Disable GUSB2PHYCFG.SUSPHY for End Transfer [ Upstream commit 3aa07f72894d209fcf922ad686cbb28cf005aaad ] If there's a disconnection while operating in eSS, there may be a delay in VBUS drop response from the connector. In that case, the internal link state may drop to operate in usb2 speed while the controller thinks the VBUS is still high. The driver must make sure to disable GUSB2PHYCFG.SUSPHY when sending endpoint command while in usb2 speed. The End Transfer command may be called, and only that command needs to go through at this point. Let's keep it simple and unconditionally disable GUSB2PHYCFG.SUSPHY whenever we issue the command. This scenario is not seen in real hardware. In a rare case, our prototype type-c controller/interface may have a slow response triggerring this issue. Signed-off-by: Thinh Nguyen <Thinh.Nguyen@xxxxxxxxxxxx> Link: https://lore.kernel.org/r/5651117207803c26e2f22ddf4e5ce9e865dcf7c7.1668045468.git.Thinh.Nguyen@xxxxxxxxxxxx Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c index dfa1d9eedde1..4812ba4bbedd 100644 --- a/drivers/usb/dwc3/gadget.c +++ b/drivers/usb/dwc3/gadget.c @@ -291,7 +291,8 @@ int dwc3_send_gadget_ep_cmd(struct dwc3_ep *dep, unsigned int cmd, * * DWC_usb3 3.30a and DWC_usb31 1.90a programming guide section 3.2.2 */ - if (dwc->gadget->speed <= USB_SPEED_HIGH) { + if (dwc->gadget->speed <= USB_SPEED_HIGH || + DWC3_DEPCMD_CMD(cmd) == DWC3_DEPCMD_ENDTRANSFER) { reg = dwc3_readl(dwc->regs, DWC3_GUSB2PHYCFG(0)); if (unlikely(reg & DWC3_GUSB2PHYCFG_SUSPHY)) { saved_config |= DWC3_GUSB2PHYCFG_SUSPHY;