This is a note to let you know that I've just added the patch titled ARM: dts: stm32: Swap PHY reset GPIO and TSC2004 IRQ on DHCOM SOM to the 5.8-stable tree which can be found at: http://www.kernel.org/git/?p=linux/kernel/git/stable/stable-queue.git;a=summary The filename of the patch is: arm-dts-stm32-swap-phy-reset-gpio-and-tsc2004-irq-on.patch and it can be found in the queue-5.8 subdirectory. If you, or anyone else, feels it should not be added to the stable tree, please let <stable@xxxxxxxxxxxxxxx> know about it. commit e25fb61f5a199044df36a5d51612cbdbaff60f37 Author: Marek Vasut <marex@xxxxxxx> Date: Fri Aug 28 14:14:12 2020 +0200 ARM: dts: stm32: Swap PHY reset GPIO and TSC2004 IRQ on DHCOM SOM [ Upstream commit 9ad98319e95263469d8ca2cb543c37c5a2f40980 ] On the production revision of the SoM, 587-200, the PHY reset GPIO and touchscreen IRQs are swapped to prevent collision between EXTi IRQs, reflect that in DT. Fixes: 34e0c7847dcf ("ARM: dts: stm32: Add DH Electronics DHCOM STM32MP1 SoM and PDK2 board") Signed-off-by: Marek Vasut <marex@xxxxxxx> Cc: Alexandre Torgue <alexandre.torgue@xxxxxx> Cc: Maxime Coquelin <mcoquelin.stm32@xxxxxxxxx> Cc: Patrice Chotard <patrice.chotard@xxxxxx> Cc: Patrick Delaunay <patrick.delaunay@xxxxxx> Cc: linux-stm32@xxxxxxxxxxxxxxxxxxxxxxxxxxxx To: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx Signed-off-by: Alexandre Torgue <alexandre.torgue@xxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> diff --git a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi index d30a3c60da9b0..a87ebc4843963 100644 --- a/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi +++ b/arch/arm/boot/dts/stm32mp15xx-dhcom-som.dtsi @@ -117,7 +117,7 @@ ðernet0 { max-speed = <100>; phy-handle = <&phy0>; st,eth-ref-clk-sel; - phy-reset-gpios = <&gpioh 15 GPIO_ACTIVE_LOW>; + phy-reset-gpios = <&gpioh 3 GPIO_ACTIVE_LOW>; mdio0 { #address-cells = <1>; @@ -285,7 +285,7 @@ touchscreen@49 { compatible = "ti,tsc2004"; reg = <0x49>; vio-supply = <&v3v3>; - interrupts-extended = <&gpioh 3 IRQ_TYPE_EDGE_FALLING>; + interrupts-extended = <&gpioh 15 IRQ_TYPE_EDGE_FALLING>; }; eeprom@50 {