On 08/28/2016 03:56 AM, --Ahmad-- wrote: > the rotation is very bad and the outgoing ip now is the ip that is > on my eth0 ipv6 address only . > i mean the lists above not working at all and all request go with 1 > ipv6 which is the ip that is on my eth0 address . > > > what wrong did i do ? I do not know. I recommend the following procedure: 1. Start with just one outgoing IP address (that is not the default!) and make that work well first. Does all from-Squid traffic originate at that alternative IP address? 2. Move to two outgoing IP addresses (none of which is the default!) and make that work well. Do you get a nice 50/50 distribution? 3. Use three IP addresses. This step will allow you to test your script. Again, make sure everything works very well before you proceed any further. Do measure the actual IP probabilities for a large number of transactions to verify that your configuration is correct. You should see ~33% of transactions using each alternative IP. 4. Move on to 1000 IP addresses. Check again. Alex. _______________________________________________ squid-users mailing list squid-users@xxxxxxxxxxxxxxxxxxxxx http://lists.squid-cache.org/listinfo/squid-users
