Thanks Marcus
I have been hacking my own branch of Squidguard so I can add support for the SNI (I hope)
How would I get the peek SNI output to the url_rewriter?
I am a bit of a peek new comer.
Sounds like there is some hope and a possible way forward.
regards
Darren B.
Sent from Mailbird
On 9/01/2016 5:46:36 PM, Marcus Kool <marcus.kool@xxxxxxxxxxxxxxx> wrote:
On 01/09/2016 05:07 AM, Darren wrote:
> Hi
>
> I am trying to hack squidguard to allow me to redirect users attempts to connect to blocked https enabled sites.
>
> Some sites are allowed and the bulk are not. Currently I can see the Connect details being handed to SG for processing and if I change this to return a redirect to make it point to a different server
> it breaks and gives me an SSL error (as would be expected)
indeed, "as expected"...
The HTTP protocol supportly support redirection of URL by sending a 30x status code back to he browser.
HTTPS, which is SSL+HTTP is "safe" encrypted channel where HTTP is inside the channel and
explicitly is designed not to be tampered with. So redirecting a channel to an other website
always will cause a certificate error, unless ...
1) one uses ssl-bump
2) installs the Squid fake CA certificate in all browsers
3) one has a policy for the other protocols (e.g. Skype) that use CONNECT
> Is there a way I can get this redirection call to squidguard happened earlier in squid before it gets this far down the CONNECT process? Or is there something that I can return from Squidguard that
> would make this work? I notice that the connect attempts are always just the IP address, so something earlier in the processing is doing a reverse DNS lookup, is this the Browser of Squid and if so
> can I get in earlier during the process?
The above implies that you use Squid in interception mode where it initially can only see the IP address of the server.
In ssl-bump mode, Squid can peek in step1 and find the SNI of the server (a.k.a the FQDN) and then the SNI/FQDN can be used in ACLs inside Squid and any URL redirector that can cope with the SNI
parameter. Squidguard cannot, the latest ufdbGuard 1.31 cannot, but ufdbGuard 1.32 _can_ and will be released in February.
Marcus
>
> I want to maintain the various lists in just squidguard and not put in ACLs in squid.conf
>
> thanks
>
> Darren B.
_______________________________________________
squid-users mailing list
squid-users@xxxxxxxxxxxxxxxxxxxxx
http://lists.squid-cache.org/listinfo/squid-users
_______________________________________________ squid-users mailing list squid-users@xxxxxxxxxxxxxxxxxxxxx http://lists.squid-cache.org/listinfo/squid-users
