On 10/07/2015 6:43 a.m., Tory M Blue wrote: > I had my build scripts working with the 3.5 betas, but i've switched over > to the mainline and I'm getting a ton of invalid switches. > > So far I've had to comment out the following, as I'm getting errors such as > > config.status: executing libtool commands > > + --enable-snmp --enable-storeio=aufs,diskd,ufs,rock --enable-wccpv2 > --enable-esi --enable-ssl --enable-ssl-crtd --enable-icmp --with-aio > --with-default-user=squid --with-filedescriptors=16384 --with-dl > --with-openssl --with-pthreads --with-included-ltdl --disable-arch-native > --without-nettle > > /var/tmp/rpm-tmp.Gsh6Y6: line 80: --enable-snmp: command not found Looks to me like you are missing an '\' character at the end of what is supposed to be a wrapped line. > > error: Bad exit status from /var/tmp/rpm-tmp.Gsh6Y6 (%build) > > #--enable-cache-digests \ Lines ike this will cause the above problem. Sine comments are not naturally wrapped in shell code. To remove an option from your list properly delete it. In cases where I need a record of the previous, I use version control, or make a long comment of the whole original shell code line(s). > Here is my configure statements (again the comments are all new as I was > trying to figure out what was going on..) > ... > > --enable-auth \ --enable-auth is not useful anymore. Its auto-enabled by default, and using any of the --enable-auth-* sub-options is equivalent to forcing it fully on like this anyway. ... > > --enable-ssl \ > --enable-ssl is no longer existing in 3.5. --with-openssl replaced it. Amos _______________________________________________ squid-users mailing list squid-users@xxxxxxxxxxxxxxxxxxxxx http://lists.squid-cache.org/listinfo/squid-users
