On Tuesday 10 March 2015 at 13:29:15 (EU time), Klavs Klavsen wrote: > Hi, > > I just setup a squid trying to get it to work in intercept mode. Is it working correctly in non-intercept mode? It can be helpful to check the simple setup first, and then try something more complex... > When I access it via port 3129 (tried from both localhost and from > another host - same problem) - using > > curl -H "Host: www.bt.dk" http://ip-of-squid-box/ Um, I don't see where you're telling curl to connect to port 3129 there (and your subject line says you have no NAT in place). > My config is: > # predefined ACLs > #acl localhost src 127.0.0.1 ::1 > #acl to_localhost dst 127.0.0.0/8 0.0.0.0/32 ::1 So, you've disabled the definition of 'localhost', and then... > # user-defined http_accesses > http_access allow localnet > http_access allow localhost > http_access deny all You're allowing from 'localnet' and 'localhost'... You also say you're getting hundreds of 127.0.0.1 entries in the log output. > # user-defined http_port > http_port 3128 So, you're listening in proxy mode on port 3128 - does this work? > http_port 3129 intercept And you're also listening on 3129 in intercept mode - does a tcpdump (on all interfaces, including lo) show any packets arriving on that port? Regards,, Antony. -- There's no such thing as bad weather - only the wrong clothes. - Billy Connolly Please reply to the list; please *don't* CC me. _______________________________________________ squid-users mailing list squid-users@xxxxxxxxxxxxxxxxxxxxx http://lists.squid-cache.org/listinfo/squid-users
