Hi Amos , Im using 3.4.3 The below config with me didn’t work. The config that worked was using the directive : acl drx proxy_auth [-i] drx this directive could match the user name with acl that I need, then I can use the acl drx in the outgoing address. All other solutins has failed. Again , thanks you for helping regards -----Original Message----- From: Amos Jeffries [mailto:squid3@xxxxxxxxxxxxx] Sent: Tuesday, October 7, 2014 10:51 PM To: Ahmed Allzaeem; squid-users@xxxxxxxxxxxxxxxxxxxxx Subject: Re: squid ipv6 outgoing addresses from ipv4 incoming traffic I should work, I recently used exactly that type of config with a client. Can you try to use the latest stable (3.4.8) please, and add "debug_options, 28,3" to your squid.conf for a trace of what ACLs are being checked. Amos On 8/10/2014 9:53 a.m., Ahmed Allzaeem wrote: > I just have one final question , I want to use tcp outgoing ipv6 based > on user authentication I mean if user A ==>ipv61 If user B ==<ipv62 > > And so on , > Actually I had treid but no luck , I have two users (Drvirus) & (drx) > all the time they go out from > > I have configured ACL user access but not sure if im wrong ! > > Thos user are stored in etc/squid/squid_user I created two of them here ! > > So now I use port 64000 and enter users drvirusx & drx but both go out > from 2a01:7e00:e000:eb::dddd I belkive they dhould go out from > 2a01:7e00:e000:eb::1111 & 2a01:7e00:e000:eb::2222 > > Can u have a look when u have time ??? > > Here is my last config > ============= > > > auth_param basic children 20 > auth_param basic realm Linux Class > auth_param basic program /lib/squid/basic_ncsa_auth > /etc/squid/squid_user auth_param basic credentialsttl 2 hours > auth_param basic casesensitive off ### acl classx proxy_auth REQUIRED > > http_access allow classx > # Recommended minimum configurat > > # Squid normally listens to port 3128 > http_port xxx:64000 > #######################users acls########### acl drvirus note user > drvirus acl drx note user drx # Uncomment and adjust th;e following to > add a disk cache directory. > #cache_dir ufs /var/cache/squid 100 16 256 > > # Leave coredumps in the first cache dir tcp_outgoing_address > 2a01:7e00:e000:eb::1111 drvirus tcp_outgoing_address > 2a01:7e00:e000:eb::2222 drx =============================== > _______________________________________________ squid-users mailing list squid-users@xxxxxxxxxxxxxxxxxxxxx http://lists.squid-cache.org/listinfo/squid-users
