On 27.06.2012 00:14, Pawel Mojski wrote:
W dniu 26-Jun-12 13:40, Pawel Mojski pisze:
W dniu 26-Jun-12 12:08, Pawel Mojski pisze:
v6priv linux # ebtables -t broute -A BROUTING -i eth0 -p ipv6
--ip-proto tcp --ip-sport 80 -j redirect --redirect-target DROP
For IP filtering the protocol must be specified as IPv4.
Ok, I've found my mistake. I should use --ip6-proto and --ip6-sport.
But, now all commands are accepter but traffic could not work.
I suppose it might be rp_filter configuration but I can not find any
rp_filter switch for ipv6.
Is rp_filter for ipv6 is enabled or disabled per default?
[...]
rp_filter per default is disabled.
All works fine, is just forgot to bind squid to 3129 port.
So, at the end of the day you have running config for tproxy ipv6 on
bridge interface.
I think it might be useful for someone.
Have a nice day to all of you.
Regards;
Pawel Mojski
Thank you very much for proving this does work :)
Wiki being checked/updated.
Amos
