On 30/03/11 02:04, Amos Jeffries wrote:
On 30/03/11 00:58, Leslie Jensen wrote:
On 2011-03-29 13:47, Amos Jeffries wrote:
On 30/03/11 00:20, Indunil Jayasooriya wrote:
I've now installed Freebsd 8.2-RELEASE on new hardware and I'm
using my
config from the 7.2 machine.
My problem is that squid is not working with transparency. The browser
traffic goes directly to the Internet.
If u r doing with PF, Can I have your pf rules?
I am doing squid 2.7.9 tranparent with OpenBSd 4.8.
These are my PF rules.
# filter rules
block in log
pass out log
pass in log on $int_if proto tcp from $lan_net to any port { 80 8080
} \
rdr-to 127.0.0.1 port 3128
in squid.conf file
http_port 3128 transparent
acl localnet src 10.0.0.0/8 # RFC1918 possible internal network
acl localnet src 172.16.0.0/12 # RFC1918 possible internal network
acl localnet src 192.168.0.0/16 # RFC1918 possible internal network
http_access allow localnet
It's worth noting the whole intercept section underwent a code change to
make the NAT lookups run-time selected. At the time care was taken not
to change the lookup sequence, but even so mistakes were found. There
were also outstanding reports that some were badly broken before the
change (doing the lookups completely backward so "myip" ACL matched the
remote client).
I have not had anyone report either "works" or "fails" for IPFW,
IPFILTER or PF on the 3.1.10 or later releases.
I believe the other modules work due to people using them successfully.
FWIW; in theory you should be able to build Squid
with them all enabled and whichever your system provides will be used.
Amos
Thank you Amos.
Would you suggest that I revert to 3.0 or even 2.7?
For the immediate result I think you should use 2.7, check that the PF
side of things is fine.
When you have confirmed a PF setup with 2.7 as working, please try 3.1
again.
I would like to know the result of that (good or bad are both useful)
and if you are able to help debug any bad results to get 3.1 fixed that
would be extra great.
Meh, nix this. See Kevins response. 3.1 works:)
Amos
--
Please be using
Current Stable Squid 2.7.STABLE9 or 3.1.11
Beta testers wanted for 3.2.0.5
